Difference between revisions of "Supported hardware"
Jump to navigation
Jump to search
Uwe Hermann (talk | contribs) |
|||
Line 32: | Line 32: | ||
| [[File:Zeroplus Logic Cube.jpg|120px|left]] | | [[File:Zeroplus Logic Cube.jpg|120px|left]] | ||
| bgcolor="lime" align="center" | [[File:Nuvola OK.png|16px]]<br />supported | | bgcolor="lime" align="center" | [[File:Nuvola OK.png|16px]]<br />supported | ||
| style="vertical-align: top" | The [[ZEROPLUS Logic Cube LAP-C]] logic analyzer | | style="vertical-align: top" | The [[ZEROPLUS Logic Cube LAP-C]] logic analyzer is supported in sigrok. | ||
|- bgcolor="#eeeeee" | |- bgcolor="#eeeeee" | ||
Line 50: | Line 50: | ||
|- bgcolor="#dddddd" | |- bgcolor="#dddddd" | ||
| [[File: | | [[File:Buspirate v3 front.jpg|120px|left]] | ||
| bgcolor=" | | bgcolor="lime" align="center" | [[File:Nuvola OK.png|16px]]<br />supported | ||
| style="vertical-align: top" | The [[ | | style="vertical-align: top" | The [[Buspirate|Buspirate v3]] supports a logic analyzer mode and can thus be used for sample captures, however only at low speeds. To quote from the announcement: ''The Bus Pirate can’t store a lot of samples, it can’t feed live samples very fast, and speeds are in the kHz range''. | ||
|- bgcolor="#eeeeee" | |- bgcolor="#eeeeee" | ||
Line 60: | Line 60: | ||
|- bgcolor="#dddddd" | |- bgcolor="#dddddd" | ||
| [[File: | | [[File:Cwav usbee sx.jpg|120px|left]] | ||
| bgcolor="yellow" align="center" | [[File:Nuvola Orange.png|16px]]<br />in progress | | bgcolor="yellow" align="center" | [[File:Nuvola Orange.png|16px]]<br />in progress | ||
| style="vertical-align: top" | The [[ | | style="vertical-align: top" | The [[CWAV USBee SX]] is a Cypress FX2 based, 8-channel logic analyzer (and signal generator). | ||
|- bgcolor="#eeeeee" | |- bgcolor="#eeeeee" | ||
Line 90: | Line 90: | ||
|- bgcolor="#dddddd" | |- bgcolor="#dddddd" | ||
| [[File: | | [[File:Dso2090-case-top-small.jpg|120px|left]] | ||
| bgcolor=" | | bgcolor="yellow" align="center" | [[File:Nuvola Red.png|16px]]<br />in progress | ||
| style="vertical-align: top" | The [[ | | style="vertical-align: top" | The [[Hantek DSO-2090]] is a 2 channel USB oscilloscope with an analog bandwidth of 40MHz and 100MS/s sampling rate. | ||
|- bgcolor="#eeeeee" | |- bgcolor="#eeeeee" | ||
Line 134: | Line 134: | ||
| style="vertical-align: top" | The [[Rigol VS5202D]] is a 2 channel analog and 16 channel digital, 200 MHz, USB-based oscilloscope/logic analyzer. | | style="vertical-align: top" | The [[Rigol VS5202D]] is a 2 channel analog and 16 channel digital, 200 MHz, USB-based oscilloscope/logic analyzer. | ||
|- bgcolor="# | |- bgcolor="#eeeeee" | ||
| [[File: | | [[File:Velleman pcsu1000 pcb front.jpg|120px|left]] | ||
| bgcolor="orange" align="center" | [[File:Nuvola Red.png|16px]]<br />planned | | bgcolor="orange" align="center" | [[File:Nuvola Red.png|16px]]<br />planned | ||
| style="vertical-align: top" | The [[ | | style="vertical-align: top" | The [[Velleman PCSU1000]] is a 2 channel USB oscilloscope with an analog bandwidth of 50MHz and 1GS/s sampling rate. | ||
|- bgcolor="#dddddd" | |- bgcolor="#dddddd" | ||
| [[File: | | [[File:Intronix Logicport.jpg|120px|left]] | ||
| bgcolor="orange" align="center" | [[File:Nuvola Red.png|16px]]<br />planned | | bgcolor="orange" align="center" | [[File:Nuvola Red.png|16px]]<br />planned | ||
| style="vertical-align: top" | The [[ | | style="vertical-align: top" | The [[Intronix Logicport|Intronix Logicport LA1034]] is an FPGA-based logic analyzer, capable of sampling data on 34 channels at up to 500MHz. It has very limited memory, however, and can only use compression at rates up to 200MHz. | ||
|} | |} |
Revision as of 13:10, 1 May 2012
sigrok is intended as a flexible, cross-platform, and hardware-independent logic analyzer software, i.e., it supports various logic analyzers from many different vendors.
Here is a list of currently supported devices (various stages of completeness) and devices we plan to support in the near future.
Device | Status | Comments |
---|---|---|
supported |
The Saleae Logic is a low-cost logic analyzer. The unit itself is very small, and has a USB 2.0 port connecting it to a PC (and powering the unit) and a connector for the 8+1 probe set. It is built around a Cypress EZ-USB FX2LP microcontroller — an 8051-compatible chip with built-in USB 2.0 controller. It can sample 8 channels up to 24MHz. | |
supported |
The EE Electronics / Eeelec XLA (a.k.a. ESLA100) is a cheap 8-channel logic analyzer (and a Saleae Logic clone). | |
supported |
The ASIX SIGMA is a 16 channel logic analyzer with sample rate support up to 200 MHz and with 256 Mbit on-board memory. | |
supported |
The Openbench Logic Sniffer (OLS) is an FPGA-based logic analyzer, supporting 32 probes for probing up to 100MHz signals and advanced trigger functionality. It is a fully open source device — the circuit design, VHDL code for the FPGA, firmware for the PIC microcontroller and Java-based client software are all freely available. The project is a collaboration between Gadget Factory and Dangerous Prototypes. | |
supported |
The ZEROPLUS Logic Cube LAP-C logic analyzer is supported in sigrok. | |
supported |
The ChronoVu LA8 is a USB-based 8-channel logic analyzer with up to 100MHz sampling rate. | |
supported |
The Robomotic MiniLogic is a Cypress FX2-based 8-channel USB logic analyzer with a maximum samplerate of 24 MHz. | |
supported |
The Logic Shrimp is a USB-based logic analyzer. | |
supported |
The Buspirate v3 supports a logic analyzer mode and can thus be used for sample captures, however only at low speeds. To quote from the announcement: The Bus Pirate can’t store a lot of samples, it can’t feed live samples very fast, and speeds are in the kHz range. | |
in progress |
The Braintechnology USB-LPS is an Cypress FX2 based logic analyzer and signal generator with up to 16 channels. | |
in progress |
The CWAV USBee SX is a Cypress FX2 based, 8-channel logic analyzer (and signal generator). | |
in progress |
The RockyLogic Ant18e is a 1GHz logic analyzer. | |
in progress |
The RockyLogic Ant8 is an 8-channel, 500MHz, USB-based logic analyzer. | |
in progress |
The Link Instruments MSO-19 is a 2GSa/s oscilloscope, 200MSa/s logic analyzer, 100MSa/s pattern generator and a TDR. It is also extremely portable and is only $249 (including probe, clips, wires and software). | |
in progress |
The EE Electronics / Eeelec ESLA201A is a USB-based, 24MHz, 8-channel logic analyzer with 2 additional analog channels. | |
in progress |
The QuantAsylum QA100 is a mixed-mode oscilloscope with 12 digital inputs, 2 analog, 1 trigger and 1 audio waveform generator. | |
in progress |
The Hantek DSO-2090 is a 2 channel USB oscilloscope with an analog bandwidth of 40MHz and 100MS/s sampling rate. | |
planned |
Pico Technology PicoScope 2203 | |
planned |
Ikalogic SCANALOGIC-2 PRO | |
planned |
The Microchip PICkit2 is a programmer/debugger for PIC microcontrollers, but it can also be used as a 3-channel logic analyzer. | |
planned |
The MiniLA Mockup is a USB-based logic analyzer. | |
planned |
The Acute PKLA-1216 is a 200MHz, 16-channel, USB-based logic analyzer. | |
planned |
The Saleae Logic16 is a 16-channel, 100/50/25/12.5MHz USB-based logic analyzer (at 2/4/8/16 enabled channels). | |
planned |
The PoLabs PoScope Basic2 is a 16-channel, 8MHz, USB-based logic analyzer (plus oscilloscope, signal/pattern generator, and more). | |
planned |
The Rigol VS5202D is a 2 channel analog and 16 channel digital, 200 MHz, USB-based oscilloscope/logic analyzer. | |
planned |
The Velleman PCSU1000 is a 2 channel USB oscilloscope with an analog bandwidth of 50MHz and 1GS/s sampling rate. | |
planned |
The Intronix Logicport LA1034 is an FPGA-based logic analyzer, capable of sampling data on 34 channels at up to 500MHz. It has very limited memory, however, and can only use compression at rates up to 200MHz. |
Potential other candidates
If you own any other logic analyzers and want to add support for them in sigrok (or donate/lend devices to developers), please let us know. We're always happy to add more hardware support! The Logic Analyzer Comparison table lists quite a few other devices we know about which may be interesting targets.