Difference between revisions of "Supported hardware"

From sigrok
Jump to navigation Jump to search
(QuantAsylum QA100)
m (Add Rigol VS5202D.)
Line 123: Line 123:
| bgcolor="orange" align="center" | [[File:Nuvola Red.png|16px]]<br />planned
| bgcolor="orange" align="center" | [[File:Nuvola Red.png|16px]]<br />planned
| style="vertical-align: top" | The [[PoLabs PoScope Basic2]] is a 16-channel, 8MHz, USB-based logic analyzer (plus oscilloscope, signal/pattern generator, and more).  
| style="vertical-align: top" | The [[PoLabs PoScope Basic2]] is a 16-channel, 8MHz, USB-based logic analyzer (plus oscilloscope, signal/pattern generator, and more).  
|- bgcolor="#dddddd"
| [[File:Rigol_VS5202D_Full.jpg|120px|left]]
| bgcolor="orange" align="center" | [[File:Nuvola Red.png|16px]]<br />planned
| style="vertical-align: top" | The [[Rigol VS5202D]] is a 2 channel analog and 16 channel digital, 200 MHz, USB-based oscilloscope/logic analyzer.


|}
|}

Revision as of 19:37, 30 January 2012

sigrok is intended as a flexible, cross-platform, and hardware-independent logic analyzer software, i.e., it supports various logic analyzers from many different vendors.

Here is a list of currently supported devices (various stages of completeness) and devices we plan to support in the near future.

Device Status Comments
Saleae Logic.jpg
Nuvola OK.png
supported
The Saleae Logic is a low-cost logic analyzer. The unit itself is very small, and has a USB 2.0 port connecting it to a PC (and powering the unit) and a connector for the 8+1 probe set. It is built around a Cypress EZ-USB FX2LP microcontroller — an 8051-compatible chip with built-in USB 2.0 controller. It can sample 8 channels up to 24MHz.
Eeelec xla esla100.jpg
Nuvola OK.png
supported
The EE Electronics / Eeelec XLA (a.k.a. ESLA100) is a cheap 8-channel logic analyzer (and a Saleae Logic clone).
ASIX SIGMA.jpg
Nuvola OK.png
supported
The ASIX SIGMA is a 16 channel logic analyzer with sample rate support up to 200 MHz and with 256 Mbit on-board memory.
Openbench logic sniffer front.jpg
Nuvola OK.png
supported
The Openbench Logic Sniffer (OLS) is an FPGA-based logic analyzer, supporting 32 probes for probing up to 100MHz signals and advanced trigger functionality. It is a fully open source device — the circuit design, VHDL code for the FPGA, firmware for the PIC microcontroller and Java-based client software are all freely available. The project is a collaboration between Gadget Factory and Dangerous Prototypes.
Zeroplus Logic Cube.jpg
Nuvola OK.png
supported
The ZEROPLUS Logic Cube LAP-C logic analyzer series should be supported in sigrok pretty soon.
Chronovu la8 device.jpg
Nuvola OK.png
supported
The ChronoVu LA8 is a USB-based 8-channel logic analyzer with up to 100MHz sampling rate.
Robomotic minilogic.jpg
Nuvola OK.png
supported
The Robomotic MiniLogic is a Cypress FX2-based 8-channel USB logic analyzer with a maximum samplerate of 24 MHz.
Logic-shrimp-front.png
Nuvola OK.png
supported
The Logic Shrimp is a USB-based logic analyzer.
Cwav usbee sx.jpg
Nuvola Orange.png
in progress
The CWAV USBee SX is a Cypress FX2 based, 8-channel logic analyzer (and signal generator).
Braintechnology usb lps.jpg
Nuvola Orange.png
in progress
The Braintechnology USB-LPS is an Cypress FX2 based logic analyzer and signal generator with up to 16 channels.
Intronix Logicport.jpg
Nuvola Orange.png
in progress
The Intronix Logicport LA1034 is an FPGA-based logic analyzer, capable of sampling data on 34 channels at up to 500MHz. It has very limited memory, however, and can only use compression at rates up to 200MHz.
Nuvola Orange.png
in progress
The RockyLogic Ant18e is a 1GHz logic analyzer.
Rockylogic ant8 device.jpg
Nuvola Orange.png
in progress
The RockyLogic Ant8 is an 8-channel, 500MHz, USB-based logic analyzer.
Nuvola Orange.png
in progress
The Link Instruments MSO-19‎ is a 2GSa/s oscilloscope, 200MSa/s logic analyzer, 100MSa/s pattern generator and a TDR. It is also extremely portable and is only $249 (including probe, clips, wires and software).
Nuvola Orange.png
in progress
The QuantAsylum QA100 is a mixed-mode oscilloscope with 12 digital inputs, 2 analog, 1 trigger and 1 audio waveform generator.
Nuvola Red.png
planned
The Buspirate v3 supports a logic analyzer mode and can thus be used for sample captures, however only at low speeds. To quote from the announcement: The Bus Pirate can’t store a lot of samples, it can’t feed live samples very fast, and speeds are in the kHz range.
Picoscope 2203 front.jpg
Nuvola Red.png
planned
Pico Technology PicoScope 2203
Ikalogic scanalogic2 device with probes.jpg
Nuvola Red.png
planned
Ikalogic SCANALOGIC-2 PRO
Microchip pickit2 device front.jpg
Nuvola Red.png
planned
The Microchip PICkit2 is a programmer/debugger for PIC microcontrollers, but it can also be used as a 3-channel logic analyzer.
Minila mockup.jpg
Nuvola Red.png
planned
The MiniLA Mockup is a USB-based logic analyzer.
Acute pkla1216 front.jpg
Nuvola Red.png
planned
The Acute PKLA-1216 is a 200MHz, 16-channel, USB-based logic analyzer.
Nuvola Red.png
planned
The Saleae Logic16 is a 16-channel, 100/50/25/12.5MHz USB-based logic analyzer (at 2/4/8/16 enabled channels).
Polabs poscope basic2 device top.jpg
Nuvola Red.png
planned
The PoLabs PoScope Basic2 is a 16-channel, 8MHz, USB-based logic analyzer (plus oscilloscope, signal/pattern generator, and more).
Nuvola Red.png
planned
The Rigol VS5202D is a 2 channel analog and 16 channel digital, 200 MHz, USB-based oscilloscope/logic analyzer.

Potential other candidates

If you own any other logic analyzers and want to add support for them in sigrok (or donate/lend devices to developers), please let us know. We're always happy to add more hardware support! The Logic Analyzer Comparison table lists quite a few other devices we know about which may be interesting targets.