Difference between revisions of "EE Electronics ESLA100"
Uwe Hermann (talk | contribs) m |
|||
| Line 31: | Line 31: | ||
See also [http://www.flickr.com/photos/uwehermann/sets/72157624520323356/ this flickr set] for more PCB photos of the device. | See also [http://www.flickr.com/photos/uwehermann/sets/72157624520323356/ this flickr set] for more PCB photos of the device. | ||
== Protocol == | |||
In sigrok, the open-source [[fx2lafw]] firmware and driver is used for this device (custom protocol). | |||
See [[Saleae Logic#Protocol]] for the original (Saleae) protocol, since this device is a [[Saleae Logic]] clone. | |||
== Resources == | == Resources == | ||
Revision as of 20:03, 10 November 2012
The EE Electronics ESLA100 is a USB-based, 8-channel logic analyzer with up to 24MHz sampling rate.
See EE Electronics ESLA100/Info for more detailed information on the device.
It ships with the Saleae Logic software and firmware, and uses the same USB VID/PID. In sigrok, the open-source fx2lafw firmware and driver is used for this device.
Hardware
- Cypress CY7C68013A-56LFXC (56pin QFN package)
- Atmel ATMLH911 02B 1
- NXP 74HC245D
Photos
Device w/ cable
Device, front
Device, back
Probe connector
USB
Device, open
PCB front
PCB back
NXP 74HC245D
Atmel ATMLH911
Cypress FX2
Probe resistors
See also this flickr set for more PCB photos of the device.
Protocol
In sigrok, the open-source fx2lafw firmware and driver is used for this device (custom protocol).
See Saleae Logic#Protocol for the original (Saleae) protocol, since this device is a Saleae Logic clone.