Difference between revisions of "CWAV USBee SX"

From sigrok
Jump to navigation Jump to search
m
Line 29: Line 29:
== Photos ==
== Photos ==


=== CY7C68013A version ===
<gallery>
<gallery>
File:Cwav usbee sx.jpg|<small>Device, front</small>
File:Cwav usbee sx.jpg|<small>Device, front</small>
Line 35: Line 36:
File:Usbee sx pcb front.jpg|<small>PCB ,front</small>
File:Usbee sx pcb front.jpg|<small>PCB ,front</small>
File:Usbee sx pcb back.jpg|<small>PCB, back</small>
File:Usbee sx pcb back.jpg|<small>PCB, back</small>
</gallery>
=== CY7C68013 (non-A) version ===
<gallery>
File:Cwav_usbee_sx_device_top.jpg|<small>Device, front</small>
File:Cwav_usbee_sx_device_bottom.jpg|<small>Device, back</small>
File:Cwav_usbee_sx_pcb_top.jpg|<small>PCB ,front</small>
File:Cwav_usbee_sx_pcb_bottom.jpg|<small>PCB, back</small>
</gallery>
</gallery>



Revision as of 23:28, 7 December 2012

CWAV USBee SX
Cwav usbee sx.png
Status supported
Source code fx2lafw
Channels 8
Samplerate 24MHz
Samplerate (state)
Triggers none (SW-only)
Min/max voltage ?
Memory none
Compression none
Website usbee.com

The USBee SX is a USB-based, 8-channel logic analyzer (and signal generator) with up to 24MHz sampling rate.

It has no firmware on board; this must be uploaded when the unit is powered on. sigrok uses the open-source fx2lafw firmware for this.

See CWAV USBee SX/Info for more detailed information on the device.

Hardware

  • Main chip: Cypress CY7C68013A-56PVXC (SSOP)
  • 3.3V voltage regulator: ST LD33
  • I2C EEPROM: Microchip 24LC01B
  • Crystal: 24MHz

Photos

CY7C68013A version

CY7C68013 (non-A) version

Protocol

Since we use the open-source fx2lafw firmware for this device, we don't need to know the protocol.

However, for those interested in this, someone else has already decoded most of it.

Resources