configure.ac: explicitly require pkg-config related macro

[libsigrokdecode.git] / decoders / i2c / pd.py

diff --git a/decoders/i2c/pd.py b/decoders/i2c/pd.py
index 6172fb438c50f9295c8786fe47d0d9672e4e4f85..b633397f563f6ae5b34327d1738b5c15fe65a026 100644 (file)
--- a/decoders/i2c/pd.py
+++ b/decoders/i2c/pd.py
@@ -18,7 +18,6 @@
 ##
 
 # TODO: Look into arbitration, collision detection, clock synchronisation, etc.
-# TODO: Implement support for 10bit slave addresses.
 # TODO: Implement support for inverting SDA/SCL levels (0->1 and 1->0).
 # TODO: Implement support for detecting various bus errors.
 
@@ -108,6 +107,9 @@ class Decoder(srd.Decoder):
     )
 
     def __init__(self):
+        self.reset()
+
+    def reset(self):
         self.samplerate = None
         self.ss = self.es = self.ss_byte = -1
         self.bitcount = 0
@@ -130,10 +132,6 @@ class Decoder(srd.Decoder):
         self.out_bitrate = self.register(srd.OUTPUT_META,
                 meta=(int, 'Bitrate', 'Bitrate from Start bit to Stop bit'))
 
-        # Assume that the initial SCL/SDA pin state is high (logic 1).
-        # This is a good default, since both pins have pullups as per spec.
-        self.initial_pins = [1, 1]
-
     def putx(self, data):
         self.put(self.ss, self.es, self.out_ann, data)
 
@@ -257,8 +255,6 @@ class Decoder(srd.Decoder):
         if not self.samplerate:
             raise SamplerateError('Cannot decode without samplerate.')
 
-        self.wait({})
-
         while True:
             # State machine.
             if self.state == 'FIND START':
@@ -272,8 +268,7 @@ class Decoder(srd.Decoder):
                 #  a) Data sampling of receiver: SCL = rising, and/or
                 #  b) START condition (S): SCL = high, SDA = falling, and/or
                 #  c) STOP condition (P): SCL = high, SDA = rising
-                conds = [{0: 'r'}, {0: 'h', 1: 'f'}, {0: 'h', 1: 'r'}]
-                pins = self.wait(conds[:]) # TODO
+                pins = self.wait([{0: 'r'}, {0: 'h', 1: 'f'}, {0: 'h', 1: 'r'}])
 
                 # Check which of the condition(s) matched and handle them.
                 if self.matched[0]: