Rigol DS1000Z series
Jump to navigation
Jump to search
 | |
| Status | supported |
|---|---|
| Channels | 4 |
| Samplerate | 1GSa/s (1ch), 500MSa/s (2ch), 250MSa/s (3 or 4 ch) |
| Analog bandwidth | 50-100MHz (depending on model) |
| Vertical resolution | 8bits |
| Triggers | edge, pulse, runt, windows, nth edge, slope, video, pattern, delay, timeout, duration, setup/hold, RS232/UART, I²C, SPI |
| Input impedance | 1MΩ‖13pF 300V RMS CAT I |
| Memory | 12/24Mpts (mode/ch-dependent) |
| Display | 7 Inch WVGA (800x480) 160,000 colours |
| Connectivity | USB host/device, ethernet (LXI), trigger out, pass/fail out |
| Features | math: +, —, x, /, FFT, vertical sensitivity: 1 mV/div to 10 V/div |
| Website | rigolna.com |
The Rigol DS1000Z Series are 4-channel oscilloscopes with an analog bandwidth of 50-100MHz and 1GSa/s maximum sampling rate.
Devices
| Model | Bandwidth |
|---|---|
| Rigol DS1054Z | 50MHz |
| Rigol DS1074Z | 70MHz |
| DS1104Z | 100MHz |
Protocol
The device uses USBTMC or LXI via its Ethernet port for communication with a host PC. The protocol is based on SCPI commands.
If you're getting persistent command errors when attempting to capture via Ethernet (try running sigrok-cli with -l 5), make sure your oscilloscope runs at least firmware version 00.04.03.02.