Difference between revisions of "UNI-T UT71x series"

From sigrok
Jump to: navigation, search
(Created page with "{{Infobox multimeter | image = 180px | name = UNI-T UT71x | status = in progress | source_code_dir = | counts...")
 
Line 2: Line 2:
 
| image          = [[File:Ut71c mugshot.png|180px]]
 
| image          = [[File:Ut71c mugshot.png|180px]]
 
| name            = UNI-T UT71x
 
| name            = UNI-T UT71x
| status          = in progress
+
| status          = supported
| source_code_dir =  
+
| source_code_dir = serial-dmm
 
| counts          = 20000/40000
 
| counts          = 20000/40000
 
| categories      = CAT III (1000V) / CAT IV (600V)
 
| categories      = CAT III (1000V) / CAT IV (600V)
Line 144: Line 144:
 
[[Category:Device]]
 
[[Category:Device]]
 
[[Category:Multimeter]]
 
[[Category:Multimeter]]
[[Category:In progress]]
+
[[Category:Supported]]

Revision as of 16:30, 25 October 2014

UNI-T UT71x
Ut71c mugshot.png
Status supported
Source code serial-dmm
Counts 20000/40000
IEC 61010-1 CAT III (1000V) / CAT IV (600V)
Connectivity RS232 / USB
Measurements voltage, resistance, diode, continuity, capacitance, frequency, duty cycle, current, temperature, power (only UT71E), loop current (not on UT71B)
Features autorange, hold, peak hold, relative, min/max, bargraph, backlight, true-rms
Website uni-trend.com

The UNI-T UT71x is a series of 20000/40000 counts, CAT III (1000V) / CAT IV (600V) handheld digital multimeters with RS232 or USB connectivity.

Devices

Device Conrad OEM Tenma OEM Counts Comments
UNI-T UT71A Voltcraft VC-920 20000
UNI-T UT71B Tenma 72-7730 20000
UNI-T UT71C 40000
UNI-T UT71D Voltcraft VC-960 (?) Tenma 72-7732 40000
UNI-T UT71E Voltcraft VC-940 Tenma 72-9380A 40000

Protocol

The devices use a simple 11-byte protocol over a USB-to-serial or USBHID-to-serial link (depending on the cable used).

The communication parameters are 2400 baud, 7o1. However, the vendor software opens the serial port with 8n1 settings, so the vendor protocol descriptions are slightly off. Also, the available vendor protocol descriptions from e.g. Conrad are partially incomplete or even erroneous in some places.

Byte Description Comments
0 Digit 1
1 Digit 2
2 Digit 3
3 Digit 4
4 Digit 5
5 Range
6 Function
7 State 1
8 State 2
9 \r (0x0d)
10 \n (0x0a)

The following information is not available/sent via the protocol (and is thus unavailable for sigrok purposes):

  • the REL, MIN, MAX, HOLD flags
  • the bargraph value
  • the backlight status
  • the low-battery indicator
  • the internal measurement value store (only available on some models)

Resources