Difference between revisions of "Sysclk SLA5032"

From sigrok
Jump to navigation Jump to search
(link to website changed to actual)
 
Line 13: Line 13:
| memory          = 2x 1Gbit DDR2 SDRAM
| memory          = 2x 1Gbit DDR2 SDRAM
| compression      = RLE
| compression      = RLE
| website          = [https://item.taobao.com/item.htm?spm=a1z10.3-c.w4002-2469271744.49.85015a069jjCWd&id=558582781203 sysclk.taobao.com]
| website          = [https://item.taobao.com/item.htm?id=601831958682 sysclk.taobao.com]
}}
}}



Latest revision as of 21:44, 13 January 2020

Sysclk SLA5032
Sysclk sla5032 mugshot.png
Status supported
Source code sysclk-sla5032
Channels 32
Samplerate 500MHz
Samplerate (state)
Triggers low, high, rising, falling
Min/max voltage -50V — 50V
Threshold voltage VIH=1.6V, VIL=1.3V
Memory 2x 1Gbit DDR2 SDRAM
Compression RLE
Website sysclk.taobao.com

The Sysclk SLA5032 is a USB-based, 32-channel logic analyzer with up to 500MHz sampling rate.

See Sysclk SLA5032/Info for more details (such as lsusb -v output) about the device.

This devices can be switched into one of three different modes (the current mode is indicated by a green LED on the respective mode text):

  • 32CH 500M: 500MHz sampling rate, 32 channels, max. 64Mbits storage per channel, support for hardware triggers (sysclk-sla5032 driver).
  • Saleae 100M: The device enumerates as a Saleae Logic16, streaming possible like with the Logic16, only software triggers (saleae-logic16 driver).
  • Saleae 500M: Similar to the above, but the max. sampling rate is actually 500MHz.

Switching between modes is done via the following mechanism: Plug the device into USB, after roughly half a second unplug it and re-plug it again. A green LED will now indicate that another mode was selected (it'll rotate through all three possible modes).

Hardware

Main board:

SODIMM daughterboard:

Photos

Firmware

In order to use this device, you need a firmware/bitstream file from the vendor software (from the CD-ROM shipped with the device or from a vendor download of the software). You can e.g. install the Windows vendor software, then get the file C:\Program Files (x86)\SLA5032\bin\top.bit, rename it to sysclk-sla5032.bit and place it in a location where libsigrok will search for firmware (see libsigrok's README.devices file for details).

Resources