PoLabs PoScope Basic2

From sigrok
Jump to navigation Jump to search
PoLabs PoScope Basic2

The PoLabs PoScope Basic2 is a 16-channel, 8MHz, USB-based logic analyzer (plus oscilloscope, signal/pattern generator, and more).

See PoLabs PoScope Basic2/Info for some more details (such as lsusb -vvv output) on the device.

Components

Photos

Protocol

Starting a sampling run

The command for starting an acquisition is a USB control transfer (request type: vendor-specific, request: 0x07, value: 0xffa0, index: 0x0000, length: 9).

The 9 bytes of data:

Byte Description Comments
0 Samplerate divider (see table below)
1
2
3
4
5 Trigger mask Bit 0 is the mask for probe 0, bit 7 is the mask for probe 7. The same byte is used as trigger mask byte for bus A or bus B (only one at a time is possible).
6
7
8

Stopping a sampling run

Sample rates

8MHz - 4MHz:

Buffer size is 128 bytes, only bus A is available, ...

Samplerate Divider
8 MHz 0x00
6 MHz 0x01
4 MHz 0x02

2.6MHz - 2MHz:

Buffer size is 1160 bytes, only bus A is available, ...

Samplerate Divider
2.6 MHz 0x03
2 MHz 0x04

1MHz - 600kHz:

Buffer size is 1544 bytes, ...

Samplerate Divider
1 MHz 0x05
900 kHz 0x05
800 kHz 0x05
700 kHz 0x05
600 kHz 0x05

500kHz and lower:

Buffer size is only limited by the PC memory, ...

Samplerate Divider
500 kHz 0x05
400 kHz 0x05
300 kHz 0x05
250 kHz 0x06
200 kHz ...
150 kHz ...
100 kHz ...
90 kHz ...
80 kHz ...
70 kHz ...
60 kHz ...
50 kHz ...
40 kHz ...
30 kHz ...
25 kHz ...
20 kHz ...
10 kHz ...
9 kHz ...
8 kHz ...
7 kHz ...
6 kHz ...
5 kHz ...
4 kHz ...
3 kHz ...
2.5 kHz ...
2 kHz ...
1 kHz ...

Sample format

Buffer size

Pre-Trigger

Trigger settings