NetBSD
This page describes how to build/install sigrok on NetBSD.
The instructions were tested on NetBSD 6.0.1, older versions may or may not have the required libs/versions to build sigrok.
Distribution packages
There are no NetBSD packages/ports yet, contributors welcome!
Building
libsigrok
Requirements:
- git
- gcc >= 4.0
- autoconf >= 2.63
- automake >= 1.11
- libtool
- pkg-config >= 0.22
- libglib >= 2.28.0
- libusb-1.0 >= 1.0.9
- libzip >= 0.8
- libftdi >= 0.16
Installing the requirements:
$ pkg_add scmgit autoconf automake libtool pkg-config glib2 libzip libftdi libusb1
Building:
$ git clone git://sigrok.org/libsigrok $ cd libsigrok $ ./autogen.sh $ ./configure $ make $ make install
libsigrokdecode
Requirements:
- git
- gcc >= 4.0
- autoconf >= 2.63
- automake >= 1.11
- libtool
- pkg-config >= 0.22
- libglib >= 2.24.0
- Python >= 3.0
Installing the requirements:
$ pkg_add scmgit autoconf automake libtool pkg-config glib2 python32
Building:
$ git clone git://sigrok.org/libsigrokdecode $ cd libsigrokdecode $ ./autogen.sh $ ./configure $ make $ make install
sigrok-cli
Requirements:
- git
- gcc >= 4.0
- autoconf >= 2.63
- automake >= 1.11
- libtool
- pkg-config >= 0.22
- libglib >= 2.28.0
- libsigrok >= 0.2.0
- libsigrokdecode >= 0.1.0
Installing the requirements:
$ pkg_add scmgit autoconf automake libtool pkg-config glib2
Building:
$ git clone git://sigrok.org/sigrok-cli $ cd sigrok-cli $ ./autogen.sh $ ./configure $ make $ make install