RadioShack 22-812
The Radioshack 22-812 is a 4000 counts, CAT II handheld digital multimeter with RS-232 connectivity. The 22-812 is no longer sold under this part number, and for a while, it appeared to have been discontinued. Radioshack does sell a visually identical multimeter, the 22-039. It is not yet clear if the Radioshack 22-039 is the same device as the 22-812.
Hardware
The micro-controller is an unidentifiable plastic blob.
This devices has a standard DB-9 connector at the top, and does not require a special adapter cable. The RS-232 transmitter is optically insulated from the rest of the device. The transmitter uses a separate PCB, integrated into the multimeter's housing. The RS-232 module is powered from the serial port.
Photos
- Radioshack 22 812 front.jpg
...
Protocol
The device periodically sends 9-byte packets at 4800 baud, 8n1. The packet includes a mode indicator, payload and checksum. the payload is a 1-1 mapping of the LCD segments.
Byte | 7 | 6 | 5 | 4 | 3 | 2 | 1 | 0 |
---|---|---|---|---|---|---|---|---|
0 | Mode | |||||||
1 | Hz | Ohms | K | M | F | A | V | m |
2 | u | n | dBm | s | % | hFE | REL | MIN |
3 | 4D | 4C | 4G | 4B | DP3 | 4E | 4F | 4A |
4 | 3D | 3C | 3G | 3B | DP2 | 3E | 3F | 3A |
5 | 2D | 2C | 2G | 2B | DP1 | 2E | 2F | 2A |
6 | 1D | 1C | 1G | 1B | MAX | 1E | 1F | 1A |
7 | Beep | Diode | Bat | Hold | - | ~ | RS232 | Auto |
8 | Checksum |
The segment lettering is
|--A--| | | F B | | |--G--| | | E C | | |--D--|
The mode is given by the following table:
0 DC V 1 AC V 2 DC uA 3 DC mA 4 DC A 5 AC uA 6 AC mA 7 AC A 8 Ohm 9 Capacitance 10 Hz (dial set to Hz) 11 Hz (dial set to DCV) 12 Hz (dial set to mA/A) 13 Duty cycle (dial set to Hz) 14 Duty cycle (dial set to DCV) 15 Duty cycle (dial set to mA/A) 16 Pulse width (dial set to Hz) 17 Pulse width (dial set to DCV) 18 Pulse width (dial set to mA/A) 19 Diode 20 Continuity (beep) 21 hFE 22 LOGIC 23 dBm 24 (Unknown) 25 Temp
Resources
- rs22812.py project page (Python interface to Radio Shack 22-812 DMM)
- Radioshack 22-812 user manual