Difference between revisions of "TekPower TP4000ZC"
| Line 1: | Line 1: | ||
[[File:Tp4000zc angle.png| | {{Infobox multimeter | ||
| image = [[File:Tp4000zc angle.png|180px]] | |||
| name = TekPower TP4000ZC | |||
| status = supported | |||
| source_code_dir = tekpower-dmm | |||
| counts = 4000 | |||
| categories = CAT II (600V) | |||
| connectivity = [[Device_cables#Digitek_DT4000ZC_cable|RS232]] | |||
| measurements = voltage, resistance, continuity, diode, capacitance, frequency, temperature, current, duty cycle | |||
| features = autorange, data hold, relative | |||
| website = NA | |||
}} | |||
The [http://www.tekpower.us TekPower TP4000ZC] is a 4000 counts, CAT II (600V) handheld digital multimeter with RS232 connectivity. | The [http://www.tekpower.us TekPower TP4000ZC] is a 4000 counts, CAT II (600V) handheld digital multimeter with RS232 connectivity. | ||
Revision as of 20:40, 27 November 2012
 | |
| Status | supported |
|---|---|
| Source code | tekpower-dmm |
| Counts | 4000 |
| IEC 61010-1 | CAT II (600V) |
| Connectivity | RS232 |
| Measurements | voltage, resistance, continuity, diode, capacitance, frequency, temperature, current, duty cycle |
| Features | autorange, data hold, relative |
| Website | NA |
The TekPower TP4000ZC is a 4000 counts, CAT II (600V) handheld digital multimeter with RS232 connectivity.
This multimeter is a rebadged Digitek DT4000ZC.
Hardware
Multimeter:
- Multimeter IC: The microcontroller is an unidentifiable plastic blob (based on the communication protocol, probably a Fortune Semiconductor FS9721_LP3)
- LM358 opamp
- HEF4013BT flip-flop
The RS-232 connector is a standard 3.5m stereo jack, with the ring left unconnected. The transmitter is optically insulated from the rest of the device. The DB-9 connector has a loopback resistor between the RX and TX pins.
Cable:
See Device_cables#Digitek_DT4000ZC_cable.
Photos
Multimeter:
Device, angle
Mugshot
Device, back
Package contents
Holster removed, front
Holster removed, back
Battery compartment
Rear cover
Front cover
Rear cover, PCB removed
PCB, front
PCB, back
Chip
HEF4013BT flip-flop
LM358 opamp
RS-232 optoisolation
RS-232 module
RS-232 PCB, bottom
RS-232 PCB, top
Cable:
See Device_cables#Digitek_DT4000ZC_cable.
Protocol
See Multimeter_ICs#Fortune_Semiconductor_FS9721_LP3.
User bit 2 is used to indicate temperature measurement in degrees Celsius.