Difference between revisions of "IEEE-488"
Jump to navigation
Jump to search
| Line 69: | Line 69: | ||
! width="30%" | Device | ! width="30%" | Device | ||
! width="20%" | Status | ! width="20%" | Status | ||
! Comments | ! Comments | ||
| Line 75: | Line 74: | ||
| [[Agilent 7xxx]] | | [[Agilent 7xxx]] | ||
| bgcolor="orange" align="center" | planned | | bgcolor="orange" align="center" | planned | ||
| style="vertical-align: top" | USB-TMC | |||
| style="vertical-align: top" | | |||
|} | |} | ||
== References == | == References == | ||
Revision as of 17:39, 24 May 2012
IEEE-488, also known as GPIB or HP-IB, comprises a set of standards which allows various test and measurement gear to be controlled and queried remotely.
The following standards are involved:
- IEEE-488.1 mechanical, electrical and basic protocol
- IEEE-488.2 formats and common commands
- SCPI standard commands, built on top of IEEE-488.2. The standard is available here
- USBTMC The USB TMC device class, standard is available here
While IEEE-488.1 defines the "Centronix-style" parallel connector, the other standards are in fact seen over other types of connections: RS-232, DB25 parallel connectors, and so on.
Sigrok aims to support all of this: all of the command sets, on any device supporting them, across any interface.
Interfaces
| Device | Status | Comments |
|---|---|---|
| Chinese 82357B clone | planned | |
| Prologix GPIB-USB | not yet supported | Hardware needed |
| Prologix GPIB-Ethernet | not yet supported | Hardware needed |
| Galvant Industries GPIB-USB board | not yet supported | Hardware needed |
| Agilent 82357B USB/GPIB interface | not yet supported | Hardware needed |
Command sets
| Command set | Status | Comments |
|---|---|---|
| SCPI | planned | |
| IEEE-488.2 | not yet supported | Standard document needed |
Devices
| Device | Status | Comments |
|---|---|---|
| Agilent 7xxx | planned | USB-TMC |
References
- IEEE-488 overview at wikipedia.
- SCPI overview at wikipedia.