Difference between revisions of "DreamSourceLab DSLogic Plus"
Jump to navigation
Jump to search
Uwe Hermann (talk | contribs) |
Andrewchen (talk | contribs) (→Photos: Add pcb photos. Note: image of back side is mirrored.) |
||
| Line 25: | Line 25: | ||
'''Device''': | '''Device''': | ||
<gallery> | <gallery> | ||
File:Dslogic_plus_pcb_front.jpg | |||
File:Dslogic_plus_pcb_back.jpg | |||
</gallery> | </gallery> | ||
Revision as of 12:30, 13 February 2018
 | |
| Status | supported |
|---|---|
| Source code | dreamsourcelab-dslogic |
| Channels | 1-16 |
| Samplerate | 400MHz(4ch), 200MHz(8ch), 100MHz(16ch) |
| Samplerate (state) | 30MHz (?) or 50MHz (?) |
| Triggers | high, low, rising, falling, edge, multi-stage triggers |
| Min/max voltage | -0.6V — 6V |
| Threshold voltage | configurable: 0-5V (0.1V increments) |
| Memory | 32MByte (2MByte/ch) |
| Compression | yes |
| Website | dreamsourcelab.com |
The DreamSourceLab DSLogic Plus is a 16-channel USB-based logic analyzer, with sampling rates up to 400MHz (when using only 4 channels). This differs slightly from the original DSLogic product in its configurable threshold voltage and different PCB layout. DreamSourceLab doesn't make the distinction between these two products very clear on their website.
See DreamSourceLab DSLogic Plus/Info for more details (such as lsusb -v output) about the device.
Hardware
Photos
Device:
Cables:
Probe cable circuit
Firmware
See DreamSourceLab DSLogic#Firmware.