Difference between revisions of "ISO-TECH IDM103N"
Jump to navigation
Jump to search
(add pictures) |
Uwe Hermann (talk | contribs) (Supported.) |
||
| Line 2: | Line 2: | ||
| image = [[File:Idm103n_01_front.png]] | | image = [[File:Idm103n_01_front.png]] | ||
| name = ISO-TECH IDM103N | | name = ISO-TECH IDM103N | ||
| status = | | status = supported | ||
| source_code_dir = serial-dmm | | source_code_dir = serial-dmm | ||
| counts = 4000 | | counts = 4000 | ||
| Line 37: | Line 37: | ||
See [[Multimeter_ICs#Cyrustek ES51978]] for the DMM IC protocol. | See [[Multimeter_ICs#Cyrustek ES51978]] for the DMM IC protocol. | ||
The transmission of the measurement data is disabled by default. The respective Cyrustek ES51978 pin (45, '''RS232''') is hooked to an IR phototransitor so an IR | The transmission of the measurement data is disabled by default. The respective Cyrustek ES51978 pin (45, '''RS232''') is hooked to an IR phototransitor so an IR LED has to be turned on in front of it to enable RS232 output. Pressing any button on any TV remote in front of it is enough to turn on the measurement transmission. | ||
== Resources == | == Resources == | ||
* [http://www.yeint.lv/en/e-store/detail.php?SECTION_ID=643&ELEMENT_ID=13195 Photo of ISO-TECH IDM73 RS232 cable] | |||
[[Category:Device]] | [[Category:Device]] | ||
[[Category:Multimeter]] | [[Category:Multimeter]] | ||
[[Category: | [[Category:Supported]] | ||
Revision as of 00:16, 7 October 2013
 | |
| Status | supported |
|---|---|
| Source code | serial-dmm |
| Counts | 4000 |
| IEC 61010-1 | CAT II (1000V) / CAT III (600V) |
| Connectivity | RS232 |
| Measurements | voltage, current, resistance, capacitance, frequency, rpm, diode, continuity |
| Features | autorange, data hold, bargraph, backlight |
| Website | iso-tech.com.cn |
The ISO-TECH IDM103N is a 4000 counts, CAT II (1000V) / CAT III (600V) handheld digital multimeter with RS232 connectivity.
Hardware
- Cyrustek ES51978 multimeter chip
Photos
Protocol
See Multimeter_ICs#Cyrustek ES51978 for the DMM IC protocol.
The transmission of the measurement data is disabled by default. The respective Cyrustek ES51978 pin (45, RS232) is hooked to an IR phototransitor so an IR LED has to be turned on in front of it to enable RS232 output. Pressing any button on any TV remote in front of it is enough to turn on the measurement transmission.