Difference between revisions of "GW Instek GDM-397"
Jump to navigation
Jump to search
(Created page with "{{Infobox multimeter | image = 180px | name = GW Instek GDM-397 | status = in progress | source_code_dir = serial-dmm...") |
|||
| Line 46: | Line 46: | ||
* [https://www.gwinstek.com/en-global/products/downloadSeriesDownNew/9914/718 Datasheet] | * [https://www.gwinstek.com/en-global/products/downloadSeriesDownNew/9914/718 Datasheet] | ||
* [https://www.gwinstek.com/en-global/products/downloadSeriesDownNew/9890/718 Manual] | |||
Revision as of 07:04, 22 August 2020
 | |
| Status | in progress |
|---|---|
| Source code | serial-dmm |
| Counts | 4000 |
| IEC 61010-1 | CAT III (1000V) / CAT IV (600V) |
| Connectivity | RS232 |
| Measurements | voltage, current, resistance, capacitance, frequency, temperature, duty cycle, diode, continuity |
| Features | autorange, true-rms, data hold, relative, backlight |
| Website | gwinstek.com |
The GW Instek GDM-397 is a 4000 count CAT III (1000V) / CAT IV (600V) handheld digital multimeter with RS232 connectivity.
It is similar to the UNI-T UT61B, but not the same device/PCB (this appears to have improvet input protection along with HRC fuses).
Hardware
Multimeter:
- Multimeter IC: Fortune Semiconductor FS9922-DMM3 (datasheet)
- Crystal: 4MHz (markings: "3.999")
- Fuses: 0.5A/600V and 10A/600V (HRV fuses)
RS232 cable:
See Device cables#UNI-T_UT-D02.
USB cable:
Photos
Front
Protocol
See Multimeter_ICs#Fortune_Semiconductor_FS9922-DMM3 for the DMM IC protocol. Depending on the cable, additional transport-specific decoding is needed, though.
Serial data transmission must be enabled by a long press on the "REL" button.