Difference between revisions of "CWAV USBee SX"
Jump to navigation
Jump to search
Uwe Hermann (talk | contribs) m |
Uwe Hermann (talk | contribs) m |
||
| Line 14: | Line 14: | ||
}} | }} | ||
The | The '''USBee SX''' is a USB-based, 8-channel logic analyzer (and signal generator) with up to 24MHz sampling rate. | ||
It has no firmware on board; this must be uploaded when the unit is powered on. sigrok uses the open-source [[fx2lafw]] firmware for this. | It has no firmware on board; this must be uploaded when the unit is powered on. sigrok uses the open-source [[fx2lafw]] firmware for this. | ||
Revision as of 20:11, 16 December 2012
 | |
| Status | supported |
|---|---|
| Source code | fx2lafw |
| Channels | 8 |
| Samplerate | 24MHz |
| Samplerate (state) | — |
| Triggers | none (SW-only) |
| Min/max voltage | ? |
| Memory | none |
| Compression | none |
| Website | usbee.com |
The USBee SX is a USB-based, 8-channel logic analyzer (and signal generator) with up to 24MHz sampling rate.
It has no firmware on board; this must be uploaded when the unit is powered on. sigrok uses the open-source fx2lafw firmware for this.
See CWAV USBee SX/Info for more detailed information on the device.
Hardware
- Main chip: Cypress CY7C68013A-56PVXC (FX2LP)
- Note: Older versions used the Cypress CY7C68013-56PVC (FX2), which is different in some ways (e.g. less SRAM)
- 3.3V voltage regulator: ST LD33
- I2C EEPROM: Microchip 24LC01B
- Crystal: 24MHz
Photos
New version with Cypress CY7C68013A (FX2LP)
Device, front
Device, back
Device, open
PCB ,front
PCB, back
Old version with Cypress CY7C68013 (FX2)
Device, front
Device, back
PCB ,front
PCB, back
"USBee ZX" marking
Protocol
Since we use the open-source fx2lafw firmware for this device, we don't need to know the protocol.
However, for those interested in this, someone else has already decoded most of it.