Difference between revisions of "CWAV USBee SX"
Jump to navigation
Jump to search
Uwe Hermann (talk | contribs) m |
Uwe Hermann (talk | contribs) m |
||
| Line 17: | Line 17: | ||
<gallery> | <gallery> | ||
File:Cwav usbee sx.jpg|<small> | File:Cwav usbee sx.jpg|<small>Device, front</small> | ||
File:Usbee sx case back.jpg|<small> | File:Usbee sx case back.jpg|<small>Device, back</small> | ||
File:Usbee sx case open.jpg|<small> | File:Usbee sx case open.jpg|<small>Device, open</small> | ||
File:Usbee sx pcb front.jpg|<small>PCB front</small> | File:Usbee sx pcb front.jpg|<small>PCB ,front</small> | ||
File:Usbee sx pcb back.jpg|<small>PCB back</small> | File:Usbee sx pcb back.jpg|<small>PCB, back</small> | ||
</gallery> | </gallery> | ||
Revision as of 19:11, 23 June 2012
The USBee SX is a USB-based, 8-channel logic analyzer (and signal generator) with up to 24MHz sampling rate.
It has no firmware on board; this must be uploaded when the unit is powered on. sigrok uses the fx2lafw firmware for this.
See CWAV USBee SX/Info for more detailed information on the device.
Hardware
- Main chip: Cypress CY7C68013A-56PVXC (SSOP)
- 3.3V voltage regulator: ST LD33
- I2C EEPROM: Microchip 24LC01B
- Crystal: 24MHz
Photos
Device, front
Device, back
Device, open
PCB ,front
PCB, back
Protocol
Since we use the open-source fx2lafw firmware for this device, we don't need to know the protocol.
However, for those interested in this, someone else has already decoded most of it.