effectively corresponds to
.BR 01 .
.br
-.BR "c" :
+.BR "e" :
Any kind of change on a pin (either a rising or a falling edge).
.sp
Not every device supports all of these trigger types. Use the \fB\-\-show\fP
.br
.B " \-A i2c=data-read:data-write,edid"
.TP
+.BR "\-M, \-\-protocol\-decoder\-meta " <pdname>
+When given, show protocol decoder meta output instead of annotations.
+The argument is the name of the decoder whose meta output to show.
+.sp
+ $
+.B "sigrok\-cli \-i <file.sr> \-M i2c"
+.sp
+Not every decoder generates meta output.
+.TP
+.BR "\-B, \-\-protocol\-decoder\-binary " <binaryspec>
+When given, decoder "raw" data of various kinds is written to stdout instead
+of annotations (this could be raw binary UART/SPI bytes, or WAV files, PCAP
+files, PNG files, or anything else; this is entirely dependent on the
+decoder and what kinds of binary output make sense for that decoder).
+.sp
+No other information is printed to stdout, so this is
+suitable for piping into other programs or saving to a file.
+.sp
+Protocol decoders that support binary output publish a list of binary
+classes, for example the UART decoder might have "TX" and "RX". To
+select TX for output, the argument to this option would be:
+.sp
+ $
+.B "sigrok\-cli \-i <file.sr> \-B uart=tx"
+.br
+.sp
+If only the protocol decoder is specified, without binary class, all classes
+are written to stdout:
+.sp
+ $
+.B "sigrok\-cli \-i <file.sr> \-B uart"
+.sp
+(this is only useful in rare cases, generally you would specify a certain
+binary class you're interested in)
+.sp
+Not every decoder generates binary output.
+.TP
.BR "\-l, \-\-loglevel " <level>
Set the libsigrok and libsigrokdecode loglevel. At the moment \fBsigrok-cli\fP
doesn't support setting the two loglevels independently. The higher the
$
.B "sigrok\-cli \-\-driver ols:conn=/dev/ttyACM0 \-\-show
.sp
-To view the documentation for a protocol decoder:
+This also works for protocol decoders, input modules and output modules:
.sp
$
-.B "sigrok\-cli \-\-protocol-decoders i2c \-\-show
+.B "sigrok\-cli \-\-protocol\-decoders i2c \-\-show
+ $
+.B "sigrok\-cli \-\-input\-format csv \-\-show
+ $
+.B "sigrok\-cli \-\-output\-format bits \-\-show
.TP
.B "\-\-scan"
Scan for devices that can be detected automatically.
.B "\-\-samples 3m"
will acquire 3000000 samples.
.TP
+.BR "\-\-frames " <numframes>
+Acquire
+.B <numframes>
+frames, then quit.
+.TP
.BR "\-\-continuous"
Sample continuously until stopped. Not all devices support this.
.TP
+.BR "\-\-get " <variable>
+Get the value of
+.B <variable>
+from the specified device and print it.
+.TP
.BR "\-\-set"
Set one or more variables specified with the \fB\-\-config\fP option, without
doing any acquisition.