Add a few OOK dumps.

[sigrok-dumps.git] / ook / oregon / wgr800 / README

diff --git a/ook/oregon/wgr800/README b/ook/oregon/wgr800/README
new file mode 100644 (file)
index 0000000..cbc26fb
--- /dev/null
+++ b/ook/oregon/wgr800/README
@@ -0,0 +1,38 @@
+-------------------------------------------------------------------------------
+WGR800: OOK data
+-------------------------------------------------------------------------------
+
+This is an example capture of an Oregon Scientific WGR800 wind sensor which
+transmits at 433.92 MHz using Manchester encoding and amplitude modulation.
+
+The signal was received by an RF Solutions RX12 superhet decoder chip and then
+passed to the logic analyser.
+
+In order to decode the Oregon v3 WGR800 you will need a preamble of '1111 ...'
+(default) in the ook decoder. Currently you can ook decode either a preamble of
+'1111 ...' or '1010 ...' but not both at the same time, so you can see Oregon
+v2.1 or v1/3 sensors.
+
+Details:
+http://www.oregonscientificstore.com/p-378-oregon-scientific-wgr800-oem-professional-wind-sensor-not-in-retail-packaging.aspx
+https://www.rfsolutions.co.uk/downloads/1481732062DS-AM-RX12.pdf
+
+
+Logic analyzer setup
+--------------------
+
+The logic analyzer used was a USBee AX Pro / Saleae Logic clone (at 25kHz):
+
+  Probe       RX12
+  ----------------
+  0           OUT
+  1           Output from Arduino running virtual BTHR968
+
+
+Data
+----
+
+ * oregon_wgr800.sr:
+   Contains a single set of pulses that belong to an Oregon Scientific WGR800
+   wind sensor. These should decode as channel 0, battery OK, rollingcode 5E,
+   direction NE(45deg), gust 3.3m/s, speed 2m/s, checksum OK.