Rename a0_dummy_write/ to a2_dummy_write.

[sigrok-dumps.git] / i2c / a2_dummy_write / README

diff --git a/i2c/a2_dummy_write/README b/i2c/a2_dummy_write/README
new file mode 100644 (file)
index 0000000..d7fe4e7
--- /dev/null
+++ b/i2c/a2_dummy_write/README
@@ -0,0 +1,36 @@
+-------------------------------------------------------------------------------
+Dummy I2C writes
+-------------------------------------------------------------------------------
+
+This an example capture of some dummy I2C traffic, where the master writes
+to a slave at address 0x51 (or 0x2a, if the read/write bit is included)
+in an infinite loop. The slave does not respond.
+
+
+Logic analyzer setup
+--------------------
+
+The logic analyzer used for capturing was a ChronoVu LA8 at a sample rate
+of 1MHz. The logic analyzer probes were connected to the I2C pins like this:
+
+  Probe       RTC chip pin
+  ------------------------
+  0 (green)   SCL
+  1 (orange)  SDA
+  GND         GND
+
+
+Data
+----
+
+This is what the decoded data should look like:
+
+ - S Wr:0xa2 A 0x55 A 0x66 A P
+
+ - The abbreviations used above: S = Start, Wr = Write, A = ACK, P = Stop
+
+The sigrok command line used was:
+
+  sigrok-cli -d 0:samplerate=1mhz --samples 8388608 \
+             -p '1=SCL,2=SDA' -o a2_dummy_write.sr
+