]>
Commit | Line | Data |
---|---|---|
1 | ------------------------------------------------------------------------------- | |
2 | PN532 NFC UART output | |
3 | ------------------------------------------------------------------------------- | |
4 | ||
5 | This is a dump of several MiFare Classic cards + tokens. | |
6 | ||
7 | For details see: | |
8 | http://www.adafruit.com/products/364 | |
9 | http://www.adafruit.com/products/365 | |
10 | http://www.adafruit.com/datasheets/pn532ds.pdf | |
11 | http://www.nxp.com/documents/data_sheet/MF1S503x.pdf | |
12 | ||
13 | ||
14 | Logic analyzer setup | |
15 | -------------------- | |
16 | ||
17 | The logic anlyzer used was a Open Logic Sniffer at a sample rate of 1MHz for | |
18 | using a baud rate of 106000 8N1. | |
19 | ||
20 | Each item's UID is within the filename of the dump. | |
21 | ||
22 | Probe UART | |
23 | ---------------- | |
24 | 0 RX | |
25 | 1 TX | |
26 | ||
27 | ||
28 | Data | |
29 | ---- | |
30 | ||
31 | The sigrok command line used was: | |
32 | ||
33 | sigrok-cli --driver=ols:conn=/dev/ttyACM0 --config rle=1:samplerate=<hz> \ | |
34 | --samples=1400000 -p '0=RX,1=TX' --triggers 'RX=0' -o <file>.sr | |
35 | ||
36 | The libnfc command line used was: | |
37 | ||
38 | ./examples/nfc-poll | |
39 | /stash/libnfc-sources/libnfc/examples/.libs/lt-nfc-poll uses libnfc libnfc-1.7.0-rc7-42-g8fe13ec | |
40 | NFC reader: pn532_uart:/dev/ttyUSB0 opened | |
41 | NFC device will poll during 30000 ms (20 pollings of 300 ms for 5 modulations) | |
42 | ISO/IEC 14443A (106 kbps) target: | |
43 | ATQA (SENS_RES): 00 04 | |
44 | UID (NFCID1): eb 95 b2 b1 | |
45 | SAK (SEL_RES): 08 | |
46 |