Sysclk LWLA1034

Sysclk LWLA1034

The Sysclk LWLA1034 is a USB-based, 34-channel logic analyzer with up to 125MHz sampling rate.

See Sysclk LWLA1034/Info for more details (such as lsusb -vvv output) about the device.

Hardware

• Altera Cyclone II FPGA
• Cypress CY7C68013A-56 (FX2) USB interface chip
• Cypress 256k×36 SRAM (likely a CY7C1361C-133AXC or similar)

Photos

• 

  PCB top view

• 

  PCB bottom view

• 

  PCB close-up

• 

  FX2

• 

  SRAM (marking removed)

Software

Firmware

• The FX2 firmware appears to be loaded from an EEPROM on the board, so that the final USB device descriptor is immediately available on power-up.
• End point 4 appears to be used exclusively for loading a new bitstream into the FPGA.
• End point 2 is apparently used for sending commands to the FPGA firmware, with responses (if any) coming in from end point 6.

Reverse engineering of the vendor protocol is currently in progress. See Sysclk LWLA1034/Protocol for a documentation of the findings gathered so far.

Resources

mcupro blog on CSDN