Talk:Tondaj SL-814

From sigrok
Revision as of 14:02, 24 May 2013 by Choogenboom (talk | contribs) (Modify Tondaj SL-814 to run off USB cable only and stay on permanently)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

We have interfaced this SPL meter to a TP-Link MR3020 running OpenWrt OS. The SL-814 had a few jumpers added to enable it to (10 always stay on and (2) be powered from the 5V on the USB connector.

Circuit mods: 1. Short C3 - causes it to turn on automatically and stay on whenever power is applied. 2. jumper USB pin 4 across to 9V power trace (the fat one) 3. Jumper C12+ to u3 pins 2+3 shorting +9 to +5 (note there are TWO 5V regulators on the board, one for digital +5 and one for Analog +5, a good design practice isolating the two) 4. short R8 making "low battery" and associated not helpful auto power off go away

Cable mods 1. My SL-814 from amazon did not come with a cable 2. the "USB" port on the SL-814 is a USB port in physical form only. What they are doing is using a USB connector to output serial TTL I/O from the Atmel's UART. it is in no way, shape orm for USB and the claims on Amazon etc that it has USB are flat out false. 3. Use a PL2303 to TTL cable and a USB type B connector donor cable. 4. connect 

  i. black - black
  ii. red - red
  iii. green - white
  iv. white - green

End Result Plug into your PC, assuming you have PL2303 driver should show up as a COM port or /dev/ttyUSBx in the case of OpenWrt/Linux.

Retrieved from "https://sigrok.org/w/index.php?title=Talk:Tondaj_SL-814&oldid=6454"