OpenBSD
This page describes how to build/install sigrok on OpenBSD.
The instructions were tested on OpenBSD 5.2, older versions may or may not have the required libs/versions to build sigrok.
Distribution packages
There are no OpenBSD packages/ports yet, contributors welcome!
Building
libsigrok
Installing the requirements:
$ pkg_add -i git autoconf automake libtool glib2 libzip libftdi Select autoconf and automake versions with the major versions as listed below (2.69 and 1.12) when asked.
Building:
$ git clone git://sigrok.org/libsigrok $ cd libsigrok $ export AUTOCONF_VERSION=2.69 AUTOMAKE_VERSION=1.12 $ ./autogen.sh $ ./configure $ make $ make install
libsigrokdecode
Installing the requirements:
$ pkg_add -i python Select python version 3.x when asked
Building:
$ git clone git://sigrok.org/libsigrokdecode $ cd libsigrokdecode $ export AUTOCONF_VERSION=2.69 AUTOMAKE_VERSION=1.12 (if you haven't exported those vars already) $ ./autogen.sh $ ./configure $ make $ make install
sigrok-cli
Installing the requirements:
$ pkg_add -r git autoconf automake libtool glib2
Building:
$ git clone git://sigrok.org/sigrok-cli $ cd sigrok-cli $ AUTOCONF_VERSION=2.69 AUTOMAKE_VERSION=1.12 ./autogen.sh $ ./configure $ make $ make install
PulseView
Note: PulseView does not build on OpenBSD at the moment, this is being investigated.
Installing the requirements:
$ pkg_add -r git libtool cmake glib2 qt4 boost-1.42.0p14
Building:
$ git clone git://sigrok.org/pulseview $ cd pulseview $ cmake . $ make $ sudo make install $ cd ..
sigrok-gtk
Note: sigrok-gtk is not yet usable!
Installing the requirements:
$ pkg_add -r git autoconf automake libtool glib2 gtk+2
Building:
$ git clone git://sigrok.org/sigrok-gtk $ cd sigrok-gtk $ AUTOCONF_VERSION=2.69 AUTOMAKE_VERSION=1.12 ./autogen.sh $ ./configure $ make $ make install
sigrok-qt
Note: sigrok-qt is not yet usable!
Installing the requirements:
$ pkg_add -r git libtool glib2 qt4
Building:
$ git clone git://sigrok.org/sigrok-qt $ cd sigrok-qt $ qmake4 $ make $ make install