PeakTech 3330

**Peaktech 3330**
Status	supported
Source code	serial-dmm
Counts	4000
IEC 61010-1	CAT III (1000V)
Connectivity	USB and RS232 cables
Measurements	voltage, current, resistance, capacitance, frequency, duty cycle, diode, continuity, temperature
Features	autorange, data hold, relative, backlight, display prompts
Website	[1] (discontinued product, and product page gone offline)

The Peaktech 3330 is a 4000 counts, CAT III (1000V) handheld digital multimeter with RS232 or USB connectivity. Accuracy is 0.5% in the DC voltage range.

In addition to the usual features, the display presents the internal temperature, and has extra indicators and prompts (disconnect power from the circuit under test for passive measurement functions, which jacks to connect the probes to depending on the selected function, when a fuse is blown).

Hardware

Multimeter:

Multimeter IC: Fortune Semiconductor FS9721_LP3
Crystal: 4MHz (markings: "4.000")
Fuse: 20A/500V (markings: HUKE R015 / RT14 RT18 / RT19)
Fuse: 500mA/250V (glass)

The U1 chip is labelled FS9711_LP3, but works flawlessly with all existing routines for FS9721. Only a TX LED is fitted in the DMM.

The fuses do NOT match the CAT III 1000V rating which is claimed on the front cover and in the paper!

There are two PCBs, with the input circuitry and range switch stacked on top of the PCB which holds the DMM chip. The top PCB is labelled "DT-9932B-3" in copper. The bottom PCB has "DT-9932B-7" as well as "2004.12.11.v.7" silk screen labels. The PCBs are connected by means of several soldered ribbon cables.

There is a COB ("U2") on pads with a QFP44 footprint. The chip is close to a big brown THT capacitor (sample'n'hold?), though the meter does not claim TRMS capabilities. Only few pins are connected, it's unlikely to be a display controller.

RS232/USB cables:

The DMM comes with both RS232 as well as USB cables. The USB cable contains a CP2102 chip. Both cables only have an RX LED.

See Peaktech 3330/Info for more details (such as lsusb -v output) about the device.