XZL_Studio AX
Revision as of 16:53, 8 November 2014 by Nihilist (talk | contribs) (→Hardware: +how to control the analog part)
 | |
| Status | supported |
|---|---|
| Source code | fx2lafw |
| Channels | 8 |
| Samplerate | 24MHz |
| Samplerate (state) | — |
| Triggers | 1 independent trigger + (SW-probe 0,1) |
| Min/max voltage |
Digital: max. 5.5V Analog: -10V — +10V |
| Threshold voltage | Digital: Fixed: VIH=1.4V, VIL=0.8V |
| Memory | none |
| Compression | none |
| Website | hotmcu.com |
The XZL_Studio AX is a USB-based, 8-channel logic analyzer with up to 24MHz sampling rate, and with 2 additional analog channels.
It is a clone of the CWAV USBee AX-Pro.
In sigrok, we use the open-source fx2lafw firmware for this logic analyzer.
Note: Only the logic analyzer functionality is supported so far, analog support is work in progress, as is the independent trigger.
See XZL_Studio AX/Info for some more details (such as lsusb -v output) on the device.
Hardware
- Main chip: Cypress CY7C68013A-56LTXC (FX2LP), U6
- ADC: 1x Texas Instruments TLC5510I (SO 24pin package), 8-Bit, 20 MSPS ADC, Single Channel, U10, outputs D1-D8 connected to PD0-PD7, OE# grounded, CLOCK from CTL2 on U6
- I2C EEPROM: Atmel 24C02C
- Low-dropout voltage regulator: Advanced Monolithic Systems AMS1117-3.3
- Crystal: 24MHz
- Multiplexer: HCF4051 - Single 8-Channel Analog Multiplexer/Demultiplexer, U12, channel selectors B and C grounded, selector A controlled by PA0 on U6
- Op Amp: LM358 - Single Supply Dual Operational Amplifiers, U15
- ...
Photos
Device, front
Probe port
USB port
Device, back
PCB, top
PCB, bottom
Probe clips
Protocol
Since we use the open-source fx2lafw firmware for this device, we don't need to know the protocol.
Resources
TODO.