Meterman 38XR
Jump to navigation
Jump to search
 | |
| Status | supported |
|---|---|
| Source code | serial-dmm |
| Counts | 10000 |
| IEC 61010-1 | CAT III (1000V) / CAT IV (600V) |
| Connectivity | RS232 |
| Measurements | voltage, current, resistance, continuity, diode, capacitance, temperature, frequency, duty cycle |
| Features | autorange, data hold, min/max, backlight |
| Website | tequipment.net |
The Meterman 38XR is a 10000 counts, CAT III 1000V, CAT IV 600V, handheld digital multimeter.
Press the RS232 button to enable the meter's transmission of measurements to the host.
Hardware
TODO.
Photos
Device, front
Device, back
PCB, top
Usage
Press the RS232 button so that RS232 lights up on the LCD.
$ sigrok-cli -d meterman-38xr:conn=/dev/ttyUSB0 --continuous $ smuview --driver meterman-38xr:conn=/dev/ttyUSB0
Protocol
The transmission of the measurement data is disabled by default. Pressing the RS232 button lights up the RS232 symbol on the display and starts transmitting data. Data is sent in 15 byte chunks consisting of 13 hex nibbles encoded in ascii, followed by <CR><LF>
| Header 1 | Header 2 |
|---|---|
| Bytes 0-1 | Function code ie. Voltage DC, Resistance, etc. |
| Bytes 2-5 | BCD (Binary coded decimal) encoding of digits shown on the LCD |
| Bytes 6-7 | Bargraph segment value |
| Byte 8 | Range code, used to convert digits to actual value |
| Byte 9 | Current mode ie AC, DC or AC+DC |
| Byte 10 | Peak status ie. Min/Max/Avg |
| Byte 11 | Range settings ie. Auto, Manual |
| Byte 12 | Polarity of meter reading |
More information can be found in the Protocol description document