Difference between revisions of "Voltcraft 18220"
Jump to navigation
Jump to search
m (Additions.) |
|||
| Line 56: | Line 56: | ||
= Resources = | = Resources = | ||
* Manual (German) available from [http://www.conrad.de Conrad Elektronik] via customer support. | * Manual (German) available from [http://www.conrad.de Conrad Elektronik] via customer support. | ||
* http://software.freepage.de/hmueller/pilot/SNT/ Control software for PalmPilot | |||
= See also = | = See also = | ||
Revision as of 09:35, 24 March 2014
| Status | in progress |
|---|---|
| Channels | 1 |
| Voltage/current (CH1) | 0-40V / 0-5A |
| Connectivity | RS232 |
| Features | settable values, settable output. |
Please note: This page is a work in progress, more to come.
The Conrad Voltcraft 18220 is a one-channel digitally-controlled laboratory power supply with RS-232 connectivity. It came onto the market in about 1996. It was sold by Conrad Elektronik as article 512923.
Hardware
- Output protection against reverse current: Max. 1 A!
Photos
Protocol
ASCII based.
Manual Operation
Status on power up
The output is disabled. Voltage and current are set to the value on previous power-off. A small negative (!) voltage can be measured while output is off.
Output Control
- On: Keep button VOLT/AMPERE pressed, press ▲.
- Off: Keep button VOLT/AMPERE pressed, press ▼.
Voltage Control
- If LED Volt is not on, press button VOLT/AMPERE.
- Press ▲ to increase voltage by 50 mV.
- Press ▼ to decrease voltage by 50 mV.
Current Control
- If LED AMPERE is not on, press button VOLT/AMPERE.
- Press ▲ to increase current limit by 100 mA.
- Press ▼ to decrease current limit by 100 mA.
- To display current current limit, shorten output externally.
Remote Operation
The sigrok driver for this device will be named voltcraft-18220.
Resources
- Manual (German) available from Conrad Elektronik via customer support.
- http://software.freepage.de/hmueller/pilot/SNT/ Control software for PalmPilot