Difference between revisions of "RDTech RD series"
Jump to navigation
Jump to search
(Add missing EN pin to WiFi header) |
|||
| Line 42: | Line 42: | ||
|1=NC | |1=NC | ||
|2=3.3V | |2=3.3V | ||
|3=<span style="color:orange">( | |3=<span style="color:orange">(PA6)</span> EN | ||
|4=GND | |4=GND | ||
|5=NC | |5=NC | ||
Revision as of 09:44, 22 September 2020
 | |
| Status | in progress |
|---|---|
| Source code | rdtech-dps |
| Channels | 1 |
| Connectivity | serial over USB/WiFi/TTL (3.3V) |
| Features | programmable presets, values, output, over-(voltage,current,power) thresholds. |
Please note: This page is a work in progress, more to come.
Hardware
- MCU: STM32F103
- U13: 2Pai Semi π122U31 Dual channel digital isolator
- U12: Gainsil GS8332 Dual Op-Amp
- U11: Winchiphead CH340E USB to serial
- U8: Winbond W25Q32JV 32MBit (4MB) SPI Flash
- U6: Fujitsu MB85RC04V 4KBit (512B) FRAM
- U1: Titan Micro TM1650 LED Driver
- U5/U0: M5333B? 3.3V regulator?
- LCD: Z240IT010 2.4" 240x320 TFT panel (ILI9341, 18pin connector, 0.8mm spacing, SPI serial)
J2 Connector Pinout:
| VDD | 1- | O | -8 | |
| BOOT0 | 2- | -7 | ||
| GND | 3- | -6 | ||
| PA14 (SWCLK) | 4- | -5 | PA13 (SWDIO) |
WiFi Header Pinout::
| NC | 1- | O | -8 | VCC |
| 3.3V | 2- | -7 | RXD (PA10 / UART1 RXD) | |
| (PA6) EN | 3- | -6 | TXD (PA9 / UART1 TXD) | |
| GND | 4- | -5 | NC |
Protocol
Modbus RTU (Wikipedia). Serial baudrate defaults to 115200/8n1 and Modbus slave address defaults to 1. Both can be changed in the main menu at any time. There is also an option using WiFi instead of USB/Serial, which uses a fixed Baudrate of 115200/8n1.
Also see the RDTech_DPS_series page. External sources exist which combine communication to DPS as well as UM as well as RD devices in a single project. Protocols may be similar enough to make a common driver desirable.
Resources
- User Manual on banggood and vendor sites
- Video Review
- EEVblog forum thread
- RD6006 Python module
- PC control and logging
- Python script for updating firmware