RDTech RD series

Riden RD6006

Status	in progress
Source code	rdtech-dps
Channels	1
Connectivity	serial over USB/WiFi/TTL (3.3V)
Features	programmable presets, values, output, over-(voltage,current,power) thresholds.

Please note: This page is a work in progress, more to come.

Hardware

• MCU: STM32F103
• U13: 2Pai Semi π122U31 Dual channel digital isolator
• U12: Gainsil GS8332 Dual Op-Amp
• U8: Winbond W25Q32JV 32MBit (4MB) SPI Flash
• U6: Fujitsu MB85RC04V 4KBit (512B) FRAM
• U1: Titan Micro TM1650 LED Driver

J2 Connector Pinout:

VDD	1-	O	-8
BOOT0	2-		-7
GND	3-		-6
PA14 (SWCLK)	4-		-5	PA13 (SWDIO)

WiFi Header Pinout::

NC	1-	O	-8	VCC
3.3V	2-		-7	RXD (PA10 / UART1 RXD)
(??) EN	3-		-6	TXD (PA9 / UART1 TXD)
GND	4-		-5	NC

Protocol

Modbus RTU (Wikipedia). Serial baudrate defaults to 115200/8n1 and Modbus slave address defaults to 1. Both can be changed in the main menu at any time. There is also an option using WiFi instead of USB/Serial, which uses a fixed Baudrate of 115200/8n1.

Also see the RDTech_DPS_series page. External sources exist which combine communication to DPS as well as UM as well as RD devices in a single project. Protocols may be similar enough to make a common driver desirable.

Resources

• User Manual on banggood and vendor sites
• Video Review
• EEVblog forum thread
• RD6006 Python module
• PC control and logging
• Python script for updating firmware

See also

• Programmable power supply
• Power supply comparison