Difference between revisions of "Agilent 34405A"
Jump to navigation
Jump to search
(provide examples for sigrok-cli use) |
(add --show to example sigrok-cli invocations, nits) |
||
| Line 33: | Line 33: | ||
$ sigrok-cli -d scpi-dmm:conn=0957.0618 --scan | $ sigrok-cli -d scpi-dmm:conn=0957.0618 --scan | ||
$ sigrok-cli -d scpi-dmm:conn=3.15 --scan | $ sigrok-cli -d scpi-dmm:conn=3.15 --scan | ||
Check the capabilities of the meter's driver, and current state of settings: | |||
$ sigrok-cli -d scpi-dmm --show | |||
Get or set the meter's current function: | Get or set the meter's current function: | ||
| Line 39: | Line 43: | ||
$ sigrok-cli -d scpi-dmm -c measured_quantity=voltage/dc --set | $ sigrok-cli -d scpi-dmm -c measured_quantity=voltage/dc --set | ||
Acquire measurement data, in the current mode or in another specified mode: | |||
$ sigrok-cli -d scpi-dmm --continuous | $ sigrok-cli -d scpi-dmm --continuous | ||
$ sigrok-cli -d scpi-dmm --time 10s | $ sigrok-cli -d scpi-dmm --time 10s | ||
$ sigrok-cli -d scpi-dmm -c measured_quantity=current/dc | $ sigrok-cli -d scpi-dmm --samples 10 -c measured_quantity=current/dc | ||
== Resources == | == Resources == | ||
Revision as of 17:33, 16 November 2018
 | |
| Status | supported |
|---|---|
| Source code | scpi-dmm |
| Counts | 120000 |
| IEC 61010-1 | CAT II (300V) / CAT I (1000VDC) |
| Connectivity | USB (USBTMC) |
| Measurements | voltage, current, resistance, capacitance, frequency, temperature, diode, continuity |
| Features | autorange, true RMS, data hold, relative |
| Website | keysight.com |
The Agilent 34405A is a 120000 count CAT II (300V) / CAT I (1000VDC) bench multimeter with USB (USBTMC) connectivity.
See Agilent 34405A/Info for USB profile information.
Photos
Example use
Scan for connected devices:
$ sigrok-cli -d scpi-dmm --scan
If other supported models or multiple devices of the same type are connected:
$ lsusb $ sigrok-cli -d scpi-dmm:conn=0957.0618 --scan $ sigrok-cli -d scpi-dmm:conn=3.15 --scan
Check the capabilities of the meter's driver, and current state of settings:
$ sigrok-cli -d scpi-dmm --show
Get or set the meter's current function:
$ sigrok-cli -d scpi-dmm --get measured_quantity $ sigrok-cli -d scpi-dmm -c measured_quantity=voltage/dc --set
Acquire measurement data, in the current mode or in another specified mode:
$ sigrok-cli -d scpi-dmm --continuous $ sigrok-cli -d scpi-dmm --time 10s $ sigrok-cli -d scpi-dmm --samples 10 -c measured_quantity=current/dc