View source for Using sigrok-cli with an oscilloscope

Oscilloscopes can be controlled using a command-line interface through [[Sigrok-cli]]. This page provides some example commands for use with the popular [[Hantek_6022BE | Hantek 6022BE]] USB oscilloscope. For a full list of commands, see the [[Sigrok-cli#Manpage | sigrok-cli manual]].

==Example sigrok-cli commands==
Display the capabilities of the device attached
   sigrok-cli --driver hantek-6xxx --show
To show the options of the channel group "CH1"
   sigrok-cli --driver hantek-6xxx --channel-group CH1 --show
Example for collecting 100 samples at 1MHz
   sigrok-cli --driver hantek-6xxx --config samplerate=1m --samples 100
For collecting samples for 100 ms
   sigrok-cli --driver hantek-6xxx --time 100
For collecting 20k samples at 1MHz sample rate and save to a csv file in the sigrok-cli directory.
May require admin rights depending on sigrok-cli install location.
   sigrok-cli --driver hantek-6xxx --config samplerate=1m --output-file test.csv --output-format csv --samples 20k
'''Note''': sigrok-cli can only be used with one Hantek 6022BE device at a time.