View source for Hantek iDSO1070

{{Infobox oscilloscope
| image               = [[File:Hantek iDSO1070A.JPG|180px]]
| name                = Hantek iDSO1070
| status              = planned
| channels            = 2
| samplerate          = 125MHz
| samplerate_equiv    = 
| bandwidth           = 70MHz
| vertical_resolution = 8bit
| triggers            = none (SW-only)
| input_impedance     = 1MΩ‖25pF
| memory              = none
| display             = none
| connectivity        = USB / Wifi
| features            = 
| website             = [http://www.hantek.com/en/productdetail_2_10165.html hantek.com]
}}

The '''Hantek iDSO1070''' is a self powered, 2-channel oscilloscope with an analog bandwidth of 70MHz with 125MSa/s sampling rate.

See [[Hantek iDSO1070/Info]] for more details (such as '''lsusb -v''' output) about the device.


== Hardware ==
* '''Main chip''': [http://www.xilinx.com/support/documentation/spartan-3an_data_sheets.htm Xilinx Spartan XC3S50A] ([http://www.xilinx.com/support/documentation/data_sheets/ds557.pdf datasheet])
* '''Main oscillator''': 50MHz 50.000 YX FH


== Photos ==

<gallery>
File:Hantek iDSO1070A inside1 front.JPG|<small></small>
File:Hantek iDSO1070A inside1 back.JPG|<small></small>
File:Hantek iDSO1070A channel module.JPG|<small></small>
File:Hantek iDSO1070A wifi module.JPG|<small></small>
File:Hantek iDSO1070A detail 1.JPG|<small></small>
</gallery>

== Protocol ==

See [https://github.com/hhornbacher/idso1070-protocol/blob/master/lib/README.md Reverse Engineered Protocol].

When the "Refresh" button is '''not''' pressed, the device run in Wifi mode, when "Refresh" button is kept pressed at boot it run in USB mode.


== Resources ==

* [https://github.com/hhornbacher/idso1070-protocol Linux Driver and Software]

[[Category:Device]]
[[Category:Oscilloscope]]
[[Category:Planned]]