hardware: A few further USB error message fixups

[libsigrok.git] / hardware / common / ezusb.c

diff --git a/hardware/common/ezusb.c b/hardware/common/ezusb.c
index 947fe1f834c1d7662c3a791a153c2aabdaafe8b5..77817a71bc36c1bc0f9307087ad5232ff11054ed 100644 (file)
--- a/hardware/common/ezusb.c
+++ b/hardware/common/ezusb.c
@@ -50,7 +50,7 @@ SR_PRIV int ezusb_reset(struct libusb_device_handle *hdl, int set_clear)
        ret = libusb_control_transfer(hdl, LIBUSB_REQUEST_TYPE_VENDOR, 0xa0,
                                      0xe600, 0x0000, buf, 1, 100);
        if (ret < 0)
-               sr_err("Unable to send control request: %s",
+               sr_err("Unable to send control request: %s.",
                                libusb_error_name(ret));
 
        return ret;
@@ -80,7 +80,7 @@ SR_PRIV int ezusb_install_firmware(libusb_device_handle *hdl,
                                              LIBUSB_ENDPOINT_OUT, 0xa0, offset,
                                              0x0000, buf, chunksize, 100);
                if (ret < 0) {
-                       sr_err("Unable to send firmware to device: %s",
+                       sr_err("Unable to send firmware to device: %s.",
                                        libusb_error_name(ret));
                        result = SR_ERR;
                        break;
@@ -104,8 +104,7 @@ SR_PRIV int ezusb_upload_firmware(libusb_device *dev, int configuration,
                libusb_get_bus_number(dev), libusb_get_device_address(dev));
 
        if ((ret = libusb_open(dev, &hdl)) < 0) {
-               sr_err("ezusb: failed to open device: %s",
-                               libusb_error_name(ret));
+               sr_err("failed to open device: %s.", libusb_error_name(ret));
                return SR_ERR;
        }