*
* Metex 14-bytes ASCII protocol parser.
*
- * @internal
* This should work for various multimeters which use this kind of protocol,
* even though there is some variation in which modes each DMM supports.
*
((!strncmp(buf, "WT", 2) && info->is_watt));
info->is_power_factor = !strncmp(buf, "CO", 2) && info->is_unitless;
info->is_hfe = !strncmp(buf, "HF", 2) ||
- (!strncmp(buf, " ", 2) && !info->is_volt && !info->is_ohm &&
- !info->is_logic && !info->is_farad && !info->is_hertz);
+ (!strncmp(buf, " ", 2) && !info->is_ampere &&!info->is_volt &&
+ !info->is_resistance && !info->is_capacity && !info->is_frequency &&
+ !info->is_temperature && !info->is_power && !info->is_power_factor &&
+ !info->is_gain && !info->is_logic && !info->is_diode);
info->is_min = !strncmp(buf, "MN", 2);
info->is_max = !strncmp(buf, "MX", 2);
info->is_avg = !strncmp(buf, "AG", 2);
return TRUE;
}
-#ifdef HAVE_LIBSERIALPORT
+#ifdef HAVE_SERIAL_COMM
SR_PRIV int sr_metex14_packet_request(struct sr_serial_dev_inst *serial)
{
const uint8_t wbuf = 'D';
+ size_t wrlen;
+ int ret;
sr_spew("Requesting DMM packet.");
- return serial_write_blocking(serial, &wbuf, 1, 0);
+ wrlen = sizeof(wbuf);
+ ret = serial_write_blocking(serial, &wbuf, wrlen, 0);
+ if (ret < 0)
+ return ret;
+ if ((size_t)ret != wrlen)
+ return SR_ERR_IO;
+
+ return SR_OK;
}
#endif