SR_MQ_TEMPERATURE,
SR_MQ_FREQUENCY,
SR_MQ_DUTY_CYCLE,
+ SR_MQ_CONTINUITY,
+ SR_MQ_PULSE_WIDTH,
+ SR_MQ_CONDUCTANCE,
+ /** For a measurement of electrical power, usually in W, or dBm */
+ SR_MQ_POWER,
+ /** Usually for measuring a transistor's gain, or h_FE*/
+ SR_MQ_GAIN,
};
/* sr_datafeed_analog.unit values */
SR_UNIT_AMPERE,
SR_UNIT_OHM,
SR_UNIT_FARAD,
- SR_UNIT_CELSIUS,
SR_UNIT_KELVIN,
+ SR_UNIT_CELSIUS,
+ SR_UNIT_FAHRENHEIT,
SR_UNIT_HERTZ,
SR_UNIT_PERCENTAGE,
+ SR_UNIT_BOOLEAN,
+ SR_UNIT_SECOND,
+ /** Unit of conductance, the inverse of resistance. */
+ SR_UNIT_SIEMENS,
+ /** An absolute measurement of power, in decibels, referenced to
+ * 1 milliwatt (dBu). */
+ SR_UNIT_DECIBEL_MW,
+ /** Voltage in decibel, referenced to 1 volt (dBV). */
+ SR_UNIT_DECIBEL_VOLT,
+ /** Measurements that intrinsically do not have units attached, such
+ * as ratios, gains, etc. Specifically, a transistor's gain (hFE) is
+ * a unitless quantity. */
+ SR_UNIT_UNITLESS,
+};
+
+/** sr_datafeed_analog.flags values */
+enum {
+ /** Voltage measurement is alternating current. */
+ SR_MQFLAG_AC = 0x01,
+ /** Voltage measurement is direct current. */
+ SR_MQFLAG_DC = 0x02,
+ /** This is a true RMS measurement. */
+ SR_MQFLAG_RMS = 0x04,
+ /** Value is voltage drop across a diode, or NAN. */
+ SR_MQFLAG_DIODE = 0x08,
+ /** Device is in "hold" mode, i.e. repeating the last measurement. */
+ SR_MQFLAG_HOLD = 0x10,
+ /** Device is in "max" mode, only updating when a new max value is found. */
+ SR_MQFLAG_MAX = 0x20,
+ /** Device is in "min" mode, only updating when a new min value is found. */
+ SR_MQFLAG_MIN = 0x40,
+ /** Device is in autoranging mode. */
+ SR_MQFLAG_AUTORANGE = 0x80,
+ /** Device is in relative mode. */
+ SR_MQFLAG_RELATIVE = 0x100,
};
+struct sr_context;
+
struct sr_datafeed_packet {
uint16_t type;
void *payload;
struct sr_datafeed_analog {
int num_samples;
- int mq; /* Measured quantity (e.g. voltage, current, temperature) */
- int unit; /* Unit in which the MQ is measured. */
+ /** Measured quantity (e.g. voltage, current, temperature) */
+ int mq;
+ /** Unit in which the MQ is measured. */
+ int unit;
+ /** Bitmap with extra information about the MQ. */
+ uint64_t mqflags;
float *data;
};
uint64_t *length_out);
int (*event) (struct sr_output *o, int event_type, uint8_t **data_out,
uint64_t *length_out);
+ GString *(*recv) (struct sr_output *o, const struct sr_dev_inst *sdi,
+ struct sr_datafeed_packet *packet);
+ int (*cleanup) (struct sr_output *o);
};
struct sr_datastore {
enum {
SR_HWOPT_DUMMY = 0, /* Used to terminate lists. Must be 0! */
- /** Some drivers cannot detect the exact model they're talking to. */
+ /** Some drivers cannot detect the exact model they're talking to
+ * (may be phased out). */
SR_HWOPT_MODEL,
- /** Specification on how to connect to a device */
+ /** Specification on how to connect to a device. In combination
+ * with SR_HWOPT_SERIALCOMM, this is a serial port in the form
+ * which makes sense to the operating system (/dev/ttyS0).
+ * Otherwise this specifies a USB device, either in the form of
+ * <bus>.<address> (decimal, e.g. 1.65) or <vendorid>.<productid>
+ * (hexadecimal, e.g. 1d6b.0001). */
SR_HWOPT_CONN,
- /** Serial communication spec: <data bits><parity><stop bit> e.g. 8n1 */
+ /** Serial communication specification, in the form:
+ * <speed>/<data bits><parity><stop bit> e.g.9600/ 8n1
+ * This is always an optional parameter, since a driver typically
+ * knows the speed at which the device wants to communicate */
SR_HWOPT_SERIALCOMM,
};
/** The device supports setting/changing its samplerate. */
SR_HWCAP_SAMPLERATE,
- /* TODO: Better description? Rename to PROBE_AND_TRIGGER_CONFIG? */
- /** The device supports setting a probe mask. */
- SR_HWCAP_PROBECONFIG,
-
/** The device supports setting a pre/post-trigger capture ratio. */
SR_HWCAP_CAPTURE_RATIO,
/* Device info IDs */
enum {
- /* struct sr_dev_inst for this specific device */
- /* TODO: obsolete */
- SR_DI_INST,
/* A list of options supported by the driver. */
SR_DI_HWOPTS,
/* A list of capabilities supported by the device. */
int (*init) (void);
int (*cleanup) (void);
GSList *(*scan) (GSList *options);
+ GSList *(*dev_list) (void);
+ int (*dev_clear) (void);
/* Device-specific */
int (*dev_open) (struct sr_dev_inst *sdi);
void *cb_data);
/* Dynamic */
- GSList *instances;
+ void *priv;
};
struct sr_session {
/* list of sr_receive_data_callback_t */
GSList *datafeed_callbacks;
GTimeVal starttime;
- gboolean running;
unsigned int num_sources;