SR_MQ_WIND_SPEED,
/** Pressure */
SR_MQ_PRESSURE,
+ /** Parallel inductance (LCR meter model). */
+ SR_MQ_PARALLEL_INDUCTANCE,
+ /** Parallel capacitance (LCR meter model). */
+ SR_MQ_PARALLEL_CAPACITANCE,
+ /** Parallel resistance (LCR meter model). */
+ SR_MQ_PARALLEL_RESISTANCE,
+ /** Serial inductance (LCR meter model). */
+ SR_MQ_SERIAL_INDUCTANCE,
+ /** Serial capacitance (LCR meter model). */
+ SR_MQ_SERIAL_CAPACITANCE,
+ /** Serial resistance (LCR meter model). */
+ SR_MQ_SERIAL_RESISTANCE,
+ /** Dissipation factor. */
+ SR_MQ_DISSIPATION_FACTOR,
+ /** Quality factor. */
+ SR_MQ_QUALITY_FACTOR,
+ /** Phase angle. */
+ SR_MQ_PHASE_ANGLE,
+ /** Difference from reference value. */
+ SR_MQ_DIFFERENCE,
};
/** Unit of measured quantity, sr_datafeed_analog.unit. */
SR_UNIT_HECTOPASCAL,
/** Relative humidity assuming air temperature of 293 kelvin (%rF). */
SR_UNIT_HUMIDITY_293K,
+ /** Plane angle in 1/360th of a full circle. */
+ SR_UNIT_DEGREE,
+ /** Henry (inductance). */
+ SR_UNIT_HENRY,
};
/** Values for sr_datafeed_analog.flags. */
SR_MQFLAG_DURATION = 0x20000,
/** Device is in "avg" mode, averaging upon each new value. */
SR_MQFLAG_AVG = 0x40000,
+ /** Reference value shown. */
+ SR_MQFLAG_REFERENCE = 0x80000,
+ /** Device selects the measured quantity automatically. */
+ SR_MQFLAG_AUTOMQ = 0x100000,
+ /** Device selects the measurement model automatically. */
+ SR_MQFLAG_AUTOMODEL = 0x200000,
};
enum sr_trigger_matches {
/** Programmable power supply. */
SR_CONF_POWER_SUPPLY,
+ /** LCR meter. */
+ SR_CONF_LCRMETER,
+
/*--- Driver scan options -------------------------------------------*/
/**
/** Over-temperature protection (OTP) */
SR_CONF_OVER_TEMPERATURE_PROTECTION,
+ /** Output frequency in Hz. */
+ SR_CONF_OUTPUT_FREQUENCY,
+
/*--- Special stuff -------------------------------------------------*/
/** Scan options supported by the driver. */