]>
Commit | Line | Data |
---|---|---|
e63e73d9 UH |
1 | ------------------------------------------------------------------------------- |
2 | Epson 8564JE I2C RTC | |
3 | ------------------------------------------------------------------------------- | |
4 | ||
709737bd UH |
5 | This an example capture of I2C traffic from/to an Epson 8564JE I2C RTC chip, |
6 | which has a slave address of 0x51 (or 0xa2, if the read/write bit is included). | |
e63e73d9 UH |
7 | |
8 | ||
9 | Logic analyzer setup | |
10 | -------------------- | |
11 | ||
47cd3c8f | 12 | The logic analyzer used was a ChronoVu LA8 (at 1MHz): |
e63e73d9 UH |
13 | |
14 | Probe RTC chip pin | |
15 | ------------------------ | |
16 | 0 (green) SCL | |
709737bd | 17 | 1 (orange) SDA |
e63e73d9 UH |
18 | |
19 | ||
20 | Data | |
21 | ---- | |
22 | ||
23 | The device talking to the RTC was doing the following in an infinite loop: | |
24 | ||
25 | - Set the RTC to a specific date/time (Nov 22, 2011 - 04:03:54, weekday = 2). | |
26 | ||
27 | - Read back the current time from the RTC. | |
28 | ||
709737bd UH |
29 | This is what the decoded data should look like: |
30 | ||
31 | - Setting the date/time: | |
32 | S Wr:0xa2 A 0x02 A 0x54 A 0x03 A 0x04 A 0x22 A 0x02 A 0x11 A 0x11 A P | |
33 | ||
34 | - Reading the current date/time: | |
35 | S Wr:0xa2 A 0x02 A Sr Rd:0xa3 A 0x54 A 0x03 A 0x44 A 0x62 A 0x52 A | |
36 | 0x51 A 0x11 N P | |
37 | ||
49d0ad90 | 38 | - The abbreviations used above: S = Start, Wr = Write, A = ACK, P = Stop, |
709737bd UH |
39 | Sr = Repeated start, Rd = Read, N = NACK |
40 | ||
e63e73d9 UH |
41 | The sigrok command line used was: |
42 | ||
43 | sigrok-cli -d 0:samplerate=1mhz --samples 8388608 \ | |
709737bd | 44 | -p '1=SCL,2=SDA' -o rtc_epson_8564je.sr |
e63e73d9 | 45 |