avr_isp: Add more parts

[libsigrokdecode.git] / decoders / maxim_ds28ea00 / __init__.py

diff --git a/decoders/maxim_ds28ea00/__init__.py b/decoders/maxim_ds28ea00/__init__.py
deleted file mode 100644 (file)
index c6f063d..0000000
--- a/decoders/maxim_ds28ea00/__init__.py
+++ /dev/null
@@ -1,56 +0,0 @@
-##
-## This file is part of the sigrok project.
-##
-## Copyright (C) 2012 Uwe Hermann <uwe@hermann-uwe.de>
-##
-## This program is free software; you can redistribute it and/or modify
-## it under the terms of the GNU General Public License as published by
-## the Free Software Foundation; either version 2 of the License, or
-## (at your option) any later version.
-##
-## This program is distributed in the hope that it will be useful,
-## but WITHOUT ANY WARRANTY; without even the implied warranty of
-## MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the
-## GNU General Public License for more details.
-##
-## You should have received a copy of the GNU General Public License
-## along with this program; if not, write to the Free Software
-## Foundation, Inc., 51 Franklin St, Fifth Floor, Boston, MA  02110-1301 USA
-##
-
-'''
-1-Wire protocol decoder.
-
-The 1-Wire protocol enables bidirectional communication over a single wire (and
-ground) between a single master and one or multiple slaves. The protocol is
-layered.
-- Link layer (reset, presence detection, reading/writing bits)
-- Network layer (skip/search/match device ROM addresses)
-- Transport layer (transport data between 1-Wire master and device)
-
-Transport layer
-
-The transport layer is the largest and most complex part of the protocol, since
-it is very device specific. The decoder is parsing only a small part of the
-protocol.
-
-Annotations:
-The next link layer annotations are shown:
-- RESET/PRESENCE True/False
-  The event is marked from the signal negative edge to the end of the reset
-  high period. It is also reported if there are any devices attached to the
-  bus.
-The next network layer annotations are shown:
-- ROM val
-  The 64bit value of the addressed device is displayed:
-  family code (1B) + serial number (6B) + CRC (1B)
-- FUNCTION COMMAND val name
-  The requested FUNCTION command is displayed as an 8bit HEX value and by name.
-- DATA val
-  Data intended for the transport layer is displayed as an 8bit HEX value.
-
-TODO:
-- add CRC checks for transport layer
-'''
-
-from .maxim_ds28ea00 import *