IKALOGIC ScanaPLUS
Revision as of 23:25, 17 July 2013 by Uwe Hermann (talk | contribs)
 | |
| Status | supported |
|---|---|
| Source code | ikalogic-scanaplus |
| Channels | 9 |
| Samplerate | 100MHz |
| Samplerate (state) | — |
| Triggers | rising, falling, logic level, pulse width |
| Min/max voltage | -35V — 35V |
| Threshold voltage | configurable per channel-group: 1.2V, 1.5V, 1.8V, 2.8V, 3.3V to 5V |
| Memory | — |
| Compression | yes |
| Website | ikalogic.com |
The Ikalogic ScanaPLUS is a USB-based, 9-channel logic analyzer with up to 100MHz sampling rate.
See Ikalogic ScanaPLUS/Info for more details (such as lsusb -vvv output) about the device.
Hardware
- FPGA with 1Mbit flash memory: Xilinx XC3S50AN (markings: "Xilinx Spartan XC3S50AN QTG144AGQ1301 D4518897A 4C") (datasheet)
- Hi-speed single-channel USB UART/FIFO: FTDI FT232H (markings: "FTDI D5RHQ.1 FT232HL 1230-B") (datasheet)
- 2x 4-bit dual-supply bus transceiver with configurable voltage translation & 3-state outputs: Texas Instruments SN74AVC4T774 (markings: "WT774 09K G4 CLS4") (datasheet)
- Low-power dual op-amp: ST LM358 (markings: "358 ET eZ022") (datasheet)
- 2Kbit Microwire EEPROM: Microchip 93LC56B (markings: "93LC56BI SN e3 1302 PVA") (datasheet)
- Dual 1.8V low-power push-pull output comparator: Microchip MCP6562 (markings: "MCP6562E SN e3 1301 RPH") (datasheet)
Photos
Package, top
Package, bottom
Package, open
Package, contents
Device w/ probes
Device, top
Device, bottom
Device, connector
Device, USB
Device, open 1
Device, open 2
PCB, top
PCB, bottom
Xilinx XC3S50AN
FTDI FT232H
TI SN74AVC4T774
TI SN74AVC4T774
ST LM358
Microchip 93LC56B
Microchip MCP6562
Protocol
TODO.