Circuits for barebone boards

This page describes which input protection / measuring circuits for barebone or other more minimal boards can be used. Usually for a Logic Analyzer high input impedance (and low capacitance) is wanted, to influence the measured circuit as least as possible (don't put an additional capacitive load on it). On the other hand, one might want to use an R-C low-pass filter for the signal to block possible higher frequency spikes. If that is wanted or required, it is best to introduce an additional buffering IC that will then drive the load of the introduced capacity of the filter.

Input protection

Clamp circuits with resistor / Z-Diodes

A clamp circuit can be used, view below there: http://sunbizhosting.co.uk/~spiral/blog/?p=117

Shown here again with numbering for fx2lafw pins:

With buffer IC

Different buffer ICs can be used in combination with resistors (+ Z-Diodes to also protect the buffer IC). Depending on the IC, they can also be used for voltage-level conversion or clamping. For example the 74HC241 can be driven at the measuring voltage up to 7V and will output to 3.3V. Buffering can also be done by latch ICs like 74HC573 (3.3V) or 74HCT573 (5V).