*/
};
-#define SR_MAX_PROBENAME_LEN 32
+#define SR_MAX_CHANNELNAME_LEN 32
/* Handy little macros */
#define SR_HZ(n) (n)
/** Constants for probe type. */
enum {
/** Probe type is logic probe. */
- SR_PROBE_LOGIC = 10000,
+ SR_CHANNEL_LOGIC = 10000,
/** Probe type is analog probe. */
- SR_PROBE_ANALOG,
+ SR_CHANNEL_ANALOG,
};
/** Information on single channel. */
struct sr_channel {
/** Number of channels, starting at 0. */
int index;
- /** Channel type (SR_PROBE_LOGIC, ...) */
+ /** Channel type (SR_CHANNEL_LOGIC, ...) */
int type;
/** Is this channel enabled? */
gboolean enabled;
SR_CONF_CENTER_FREQUENCY,
/** The device supports setting the number of logic probes. */
- SR_CONF_NUM_LOGIC_PROBES,
+ SR_CONF_NUM_LOGIC_CHANNELS,
/** The device supports setting the number of analog probes. */
- SR_CONF_NUM_ANALOG_PROBES,
+ SR_CONF_NUM_ANALOG_CHANNELS,
/** Output voltage. */
SR_CONF_OUTPUT_VOLTAGE,
const struct sr_dev_inst *sdi,
const struct sr_channel_group *cg);
/** Probe status change.
- * @see sr_dev_probe_enable(), sr_dev_trigger_set(). */
- int (*config_probe_set) (const struct sr_dev_inst *sdi,
+ * @see sr_dev_channel_enable(), sr_dev_trigger_set(). */
+ int (*config_channel_set) (const struct sr_dev_inst *sdi,
struct sr_channel *ch, unsigned int changes);
/** Apply configuration settings to the device hardware.
* @see sr_config_commit().*/