- mic-985xx (including all subdrivers)
- norma-dmm
- openbench-logic-sniffer
+ - pipistrello-ols
- rigol-ds
- serial-dmm (including all subdrivers)
- teleinfo
- uni-t-dmm (including all subdrivers)
- uni-t-ut32x
- victor-dmm
+ - yokogawa-dlm
- zeroplus-logic-cube
- ikalogic-scanaplus
- kecheng-kc-330b
- lascar-el-usb
+ - pipistrello-ols
- rigol-ds (USBTMC or TCP)
- saleae-logic16
- sysclk-lwla
- uni-t-dmm (including all subdrivers)
- uni-t-ut32x
- victor-dmm
+ - yokogawa-dlm (USBTMC or TCP)
- zeroplus-logic-cube
-Specifiying serial port parameters
-----------------------------------
+Specifying serial port parameters
+---------------------------------
Every serial device's driver has default serial port parameters like baud
rate, number of data bits, stop bits and handshake status. If a device requires
- Tenma 72-7750: Briefly press the "RS232C" button.
- UNI-T UT60G: Briefly press the "RS232C" button.
- UNI-T UT61B/C/D: Press the "REL/RS232/USB" button for roughly 1 second.
+ - UNI-T UT71x: Press the "SEND/-/MAXMIN" button for roughly 1 second.
+ Briefly pressing the "EXIT" button leaves this mode again.
- UNI-T UT325: Briefly press the "SEND" button (as per manual). However, it
appears that in practice you don't have to press the button (at least on
some versions of the device), simply connect the device via USB.
- V&A VA18B/VA40B: Keep the "Hz/DUTY" key pressed while powering on the DMM.
- Victor 70C/86C: Press the "REL/RS232" button for roughly 1 second.
- Voltcraft VC-830: Press the "REL/PC" button for roughly 2 seconds.
+ - Voltcraft VC-870: Press the "REL/PC" button for roughly 1 second.
ChronoVu LA8/LA16 USB VID/PIDs