1 -------------------------------------------------------------------------------
3 -------------------------------------------------------------------------------
5 This is a set of files saved/exported from the Agilent MSO7034A oscilloscope.
8 http://www.keysight.com/en/pd-1293631-pn-MSO7034A/mixed-signal-oscilloscope-350-mhz-4-analog-plus-16-digital-channels
14 The oscilloscope has the following options in the 'Save/Recall' menu, that
15 can be used to save the acquired/displayed data on a USB thumb drive:
18 - Used to store the data *in* the scope (not on USB thumb drive)
19 - BMP (8-bit) image file
20 - Options: Setup info = y/n, Invert Grat = y/n, Palette = Color/Grayscale
21 - BMP (24-bit) image file
22 - Options: Setup info = y/n, Invert Grat = y/n, Palette = Color/Grayscale
23 - PNG (24-bit) image file
24 - Options: Setup info = y/n, Invert Grat = y/n, Palette = Color/Grayscale
26 - Options: Setup info = y/n, Length = 100/250/500/1000
28 - Options: Setup info = y/n, Length = x
29 (x = 100/250/500/1000/2000/5000/10000/20000/50000/100000/200000/500000
32 - Options: Setup info = y/n, Length = x (see above),
33 Alb serial format = Default/CAN/I2C/LIN/UART|RS232/SPI2/SPI3/SPI4
35 - Options: Setup info = y/n, Length = x (see above)
39 When "Setup info" is enabled, the scope also saves an additional file
40 with the respective basename and a *.txt extention (e.g. "scope_0.txt"),
41 which contains some ASCII info about the scope setup, any measurements
42 displayed on the LCD, and so on.
48 Channels 1 and 2 of the (4-channel) scope were connected to the test output
49 of the scope (used for probe impedance matching), which outputs a 1.2kHz
50 square wave signal with an amplitude of 2.5V (2.72V peak-to-peak).
52 After the "Stop" button was pressed, the following files were saved:
61 scope_7: ASCII XY, 100
62 scope_8: ASCII XY, 250
64 scope_19: ASCII XY, 1000000
65 scope_20: ASCII XY, 2000000
66 scope_21: ALB, 100, Default
67 scope_22: ALB, 100, CAN
68 scope_23: ALB, 100, I2C
69 scope_24: ALB, 100, LIN
70 scope_25: ALB, 100, UART/RS232
71 scope_26: ALB, 100, SPI2 (SPI3/4 cannot be be used with only 2 channels)
77 Only two "Setup info" files are included, scope_0.txt and scope_4.txt.
78 The first one is valid (and identical) for files scope_0* to scope_3*, the
79 latter is valid (and identical) for the files scope_4* to scope_30*.
81 The *.bin files contain the device's serial number. This has been changed
82 (via hex editor) to "MY12345678" in the files.