Difference between revisions of "RDTech RD series"

From sigrok
Jump to navigation Jump to search
Line 24: Line 24:
* U1: Titan Micro TM1650 LED Driver
* U1: Titan Micro TM1650 LED Driver
* U5/U0: M5333B? 3.3V regulator?
* U5/U0: M5333B? 3.3V regulator?
* LCD: Z240IT010 2.4" SPI TFT panel (ILI9341, 18pin connector, 0.8mm spacing)
* LCD: Z240IT010 2.4" 240x320 TFT panel (ILI9341, 18pin connector, 0.8mm spacing, SPI serial)


'''J2 Connector Pinout:'''
'''J2 Connector Pinout:'''

Revision as of 20:36, 8 September 2020

Riden RD6006
RD6006 frontpanel.png
Status in progress
Source code rdtech-dps
Channels 1
Connectivity serial over USB/WiFi/TTL (3.3V)
Features programmable presets, values, output, over-(voltage,current,power) thresholds.

Please note: This page is a work in progress, more to come.

Hardware

Rd6006 detail.jpg

  • MCU: STM32F103
  • U13: 2Pai Semi π122U31 Dual channel digital isolator
  • U12: Gainsil GS8332 Dual Op-Amp
  • U11: Winchiphead CH340E USB to serial
  • U8: Winbond W25Q32JV 32MBit (4MB) SPI Flash
  • U6: Fujitsu MB85RC04V 4KBit (512B) FRAM
  • U1: Titan Micro TM1650 LED Driver
  • U5/U0: M5333B? 3.3V regulator?
  • LCD: Z240IT010 2.4" 240x320 TFT panel (ILI9341, 18pin connector, 0.8mm spacing, SPI serial)

J2 Connector Pinout:

VDD 1-   O -8
BOOT0 2- -7
GND 3- -6
PA14 (SWCLK) 4- -5 PA13 (SWDIO)

WiFi Header Pinout::

NC 1-   O -8 VCC
3.3V 2- -7 RXD (PA10 / UART1 RXD)
(??) EN 3- -6 TXD (PA9 / UART1 TXD)
GND 4- -5 NC

Protocol

Modbus RTU (Wikipedia). Serial baudrate defaults to 115200/8n1 and Modbus slave address defaults to 1. Both can be changed in the main menu at any time. There is also an option using WiFi instead of USB/Serial, which uses a fixed Baudrate of 115200/8n1.

Also see the RDTech_DPS_series page. External sources exist which combine communication to DPS as well as UM as well as RD devices in a single project. Protocols may be similar enough to make a common driver desirable.

Resources

See also