Difference between revisions of "Mcupro Logic16 clone"
Jump to navigation
Jump to search
Whitequark (talk | contribs) |
Whitequark (talk | contribs) |
||
| Line 38: | Line 38: | ||
== Firmware == | == Firmware == | ||
The firmware extraction steps are identical to [[Saleae_Logic16#Firmware]], however you only need to have saleae-logic16-fx2.fw installed. | The firmware extraction steps are identical to [[Saleae_Logic16#Firmware steps for Saleae Logic16]], however you only need to have saleae-logic16-fx2.fw installed. | ||
== Photos == | == Photos == | ||
Revision as of 20:26, 22 August 2014
 | |
| Status | planned |
|---|---|
| Source code | saleae-logic16 |
| Channels | 3/6/9/16 |
| Samplerate | 100/50/32/16MHz |
| Samplerate (state) | — |
| Triggers | none (SW-only) |
| Min/max voltage | -0.9V — 6V |
| Threshold voltage | 1.5V (operates with 3.3V logic) |
| Memory | none |
| Compression | yes |
| Website | [1] |
The mcupro Saleae16 is a USB-based, 16-channel logic analyzer with 100/50/32/16MHz sampling rate (at 3/6/9/16 enabled channels).
This is a clone of the Saleae Logic16.
See Mcupro Saleae16/Info for more details (such as lsusb -vvv output) about the device.
Hardware
- FPGA: Actel A3P125
- USB interface chip: Cypress CY7C68013A
- I2C EEPROM: Atmel 24C02N
- 3.3V voltage regulator: Advanced Monolithic Systems AMS1117-3.3
- 1.2V voltage regulator: Advanced Monolithic Systems AMS1117-1.5
- Crystal: 24.000MHz
Operation
This logic analyzer works with unmodified Saleae software. The Actel FPGA has on-chip flash storage, so it only requires an upload of Cypress FX2LP firmware in order to operate.
Firmware
The firmware extraction steps are identical to Saleae_Logic16#Firmware steps for Saleae Logic16, however you only need to have saleae-logic16-fx2.fw installed.
Photos
