Difference between revisions of "BBC Goertz Metrawatt M2110"

From sigrok
Jump to navigation Jump to search
Line 56: Line 56:
The device is supported by the driver ''bbcgm-m2110'' in modes that send data automatically or manually. Polling is not implemented.  
The device is supported by the driver ''bbcgm-m2110'' in modes that send data automatically or manually. Polling is not implemented.  


The device detection requires a message to be sent by the device within 10s. The default serial port parameters are 1200/7n2.
The device detection requires a message to be sent by the device within 1s. The default serial port parameters are 1200/7n2.


After power on or configuration changes the button ''Start/Reset'' must be pressed at least once to initiate sending.
After power on or configuration changes the button ''Start/Reset'' must be pressed at least once to initiate sending.

Revision as of 13:07, 19 December 2013

BBC Goertz Metrawatt M2110
Bbcg m2110 8.jpg
Status supported
Source code serial-dmm
Counts 30000
Connectivity RS232
Measurements voltage, current, resistance, capacitance
Features manual range

The BBC Goertz Metrawatt M2110 is a historic (about 1984) 30000 count bench multimeter with RS232 connectivity.

A multimeter called Metravo 5D from the same manufacturer that seems to be the same model without RS232 port received the iF design awards in 1981.

The manufacturer is called Gossen Metrawatt today.

Hardware

RS232 Interface:

  • Baud rates 150/300/600/1200/2400/4800/9600, configurable via rotary switch
  • 7 data bits
  • No/even/odd parity bit, configurable via DIP switches
  • 1 or 2 stop bits, configurable via DIP switch
  • Optional CTS handshake, configurable via DIP switch
  • Output intervals 0,66s/10s/1m/10m/1h/manual/remote controlled, configurable via rotary switch
  • Manual output sends value on button Start/Reset pressed.
  • Remote controlled output sends data on CTS set or ENQ sent, configurable via DIP switches
  • Max. 1,5 measurements/s.

RS232 cable:

  • 25 pin "female" connector
  • Null modem cable required (DTE configuration)!

Photos

Protocol

msg := SDDDDDD | 'OVERRNG'  CR LF
S := '-' | ' '
D := '0'..'9'|'.'

Unfortunately the device does not send the measured unit.

Support in sigrok

The device is supported by the driver bbcgm-m2110 in modes that send data automatically or manually. Polling is not implemented.

The device detection requires a message to be sent by the device within 1s. The default serial port parameters are 1200/7n2.

After power on or configuration changes the button Start/Reset must be pressed at least once to initiate sending.

Resources