-Probes:
-1-Wire requires a single signal, but some master implementations might have a
-separate signal use to deliver power to the bus during temperature conversion
-as an example. This power signal is currently not parsed.
-- owr (1-Wire bus)
-- pwr (1-Wire power)
-
-Options:
-1-Wire is an asynchronous protocol, so the decoder must know the sample rate.
-The timing for sampling bits, presence and reset is calculated by the decoder,
-but in case the user wishes to use different values, it is possible to
-configure the next timing values (number of sample rate periods):
-- overdrive (if active the decoder will be prepared for overdrive)
-- cnt_normal_bit (time for normal mode sample bit)
-- cnt_normal_presence (time for normal mode sample presence)
-- cnt_normal_reset (time for normal mode reset)
-- cnt_overdrive_bit (time for overdrive mode sample bit)
-- cnt_overdrive_presence (time for overdrive mode sample presence)
-- cnt_overdrive_reset (time for overdrive mode reset)
-This options should be configured only on very rare cases and the user should
-read the decoder source code to understand them correctly.
+The transport layer is the largest and most complex part of the protocol, since
+it is very device specific. The decoder is parsing only a small part of the
+protocol.