]> sigrok.org Git - libsigrok.git/blobdiff - README.devices
scpi-pps: Support for the EEZ PSU series
[libsigrok.git] / README.devices
index 1183b460ac045a8bbcca7f60bc8bf5624f5d69de..3e9b631f75f9936708f5505e23499a47eeec0fe9 100644 (file)
@@ -98,7 +98,6 @@ The following drivers/devices do not need any firmware upload:
  - atten-pps3xxx
  - baylibre-acme
  - beaglelogic
- - brymen-dmm
  - cem-dt-885x
  - center-3xx (including all subdrivers)
  - chronovu-la
@@ -136,6 +135,7 @@ The following drivers/devices do not need any firmware upload:
  - pce-322a
  - pipistrello-ols
  - rdtech-dps
+ - rigol-dg
  - rigol-ds
  - rohde-schwarz-sme-0x
  - scpi-dmm
@@ -211,6 +211,12 @@ or VXI communication parameters. See these examples:
  $ sigrok-cli --driver <somedriver>:conn=vxi/<ipaddr> ...
  $ sigrok-cli --driver <somedriver>:conn=usbtmc/<bus>.<addr> ...
 
+Individual device drivers _may_ implement additional semantics for the
+conn= specification, which would not apply to other drivers, yet can be
+rather useful for a given type of device.
+
+ $ sigrok-cli --driver <somedriver>:conn=sn=<serno>
+
 
 Specifying serial port parameters
 ---------------------------------
@@ -408,6 +414,7 @@ a short list for convenience:
  - GW Instek VCP: See the discussion on manual driver assignment to common
    USB to UART chips with non-default USB identification.
  - MASTECH MS6514: Press the "Setup/PC-Link" button for roughly 3 seconds.
+ - Meterman 38XR: Press the "RS232" button.
  - Metrix MX56C: Press the PRINT button to have the meter send acquisition
    data via IR. Hold the PRINT button to adjust the meter's transmission
    interval.
@@ -471,6 +478,16 @@ Example:
  $ sigrok-cli --driver ols:conn=/dev/ttyACM0 ...
 
 
+JTAGulator
+----------
+
+The Grand Idea Studio JTAGulator also implements the SUMP protocol and
+thus is covered by the OLS driver. See the vendor's wiki on details how
+to enable the Logic Analyzer mode of operation.
+
+  https://github.com/grandideastudio/jtagulator/wiki/Logic-Analyzer
+
+
 Mooshimeter
 -----------